- June 8: Chevy Bolt Battery Lawsuit Settlement Reached news | 4 days ago
- May 22: GM Duramax Diesel Lawsuit Awaiting Appeals Court Decision news | 21 days ago
- May 7: GM Transmission Lawsuit Affects Hydra-Matic 8L90 and 8L45 news | 36 days ago
- April 17: GM Shift to Park Recall Needed, Alleges Class Action Lawsuit news | 56 days ago
Chevrolet TSB #PIP5345A
2017 Chevrolet Silverado 1500
TSB Document:
Affected Component: POWER TRAIN
- Summary
- This Preliminary Information communication provides information to the technician about being to achieve pre-load when setting up the pinion bearing pre-loads during reassembly of the 9.5/9.76 inch rear axles. Technician will need to use pinion gear install washer part number 11609638 onto the pinion shaft between the flange and nut. Tighten the pinion nut until you achieve 10 pound inch or 1.0 newton rotating torque. After the torque has been achieved back the nut off and remove the washer. Tighten the nut back down until you achieve 15 pound inch or 1.7 newton meters for used bearings or 20 pound inch 2.25 newton meters for new bearings.
Click a tab for more information.