NHTSA Campaign #94V176000 STRUCTURE:BODY:DOOR

SEPTEMBER 20
1994

1,604 vehicles recalled

1994 CHEVROLET BERETTA -- The reinforcement panel that serves as a liftpoint for the frame was omitted from the right side rocker assembly of the frame the vehicles do not conform to the requirements of FMVSS no. 208, "Occupant Crash Protection."

Consequence of non-compliance: The missing reinforcement panel reduces the protection of the vehicle occupants in the event of a side impact collision.

Dealers will inspect the vehicles for the presence of the right side rocker reinforcement panel. If the reinforcement panel is not present, dealers will contact Chevrolet for further instructions. For detailed information & supporting documents, see the official NHTSA page concerning recall #94V176000 »

NHTSA Campaign #93V157000 SUSPENSION:FRONT

SEPTEMBER 24
1993

39 vehicles recalled

1994 CHEVROLET BERETTA -- The suspension support assemblies do not meet General Motors corporation's specification for weld integrity and the affected weld can fail causing the front of the control arm to separate from the suspension support assembly.

If this occurs, the affected tire/wheel assembly can movesubstantially from its designed position and steering control can be severelyimpaired which may result in an accident.

Install revised suspension supports with adequate weld integrity. For detailed information & supporting documents, see the official NHTSA page concerning recall #93V157000 »