This data is from the NHTSA — the US gov't agency tasked with vehicle safety. Complaints are spread across multiple & redundant categories, & are not organized by problem.
So how do you find out what problems are occurring? For this NHTSA complaint data, the only way is to read through the comments below. Any duplicates or errors? It's not us.
When the brakes were depressed, the front end of the vehicle vibrated. Which was caused by a failed disc brake, the dealer replaced the disc brake, however the problem recurred.
A number of Dodge trucks have this same problem, mild to severe pulling when braking, mine is so bad that it will change lanes unless you counter steer just before hitting the brakes.
Front right brake caliper keeps pulling shortly after replacement. 4 have been replaced. Sometimes a very strong pull where steering is pulled from hands. Especially dangerious when pulling a travel trailer. -- fuel cell has a badly worn sleeve which causes floating suction to hang up causing air suction and running out of fuel at 1/2 tank plus or minus.
While coming down a hill and turning a load, applied the brakes and the whole front end shook violently. Also, steering wheel vibrated right and left. Contacted dealer.
- Pueblo, CO, USA
Search CarComplaints.com for these popular complaint phrases...
When applying brakes vehicle will pulls hard to left. Dealer has resurfaced front brakes, and flushed master cylinder and its lines, but defect keeps reoccurring.
For 3 years and 30,000 miles, I have made 3 trips to reno Dodge for service under warranty because the vehicle does not drive straight. It pulls to the right. For the last three years, Dodge has told me that it doesn't. after my trip to Kansas and keeping the wheel cranked 1/4 turn to the left to keep the truck going straight, all the way there and back, I was fed up.
Excessive pedal effort required to stop vehicle in normal braking situations. Front brakes smoke during hard stops or in stop and go traffic. It also gives off a burning smell. Brought back to dealer 2 times and they state that it is "normal". I just found out that in 1997, Dodge changed the master cylinder on this truck to a larger unit. The rest of the brake system components are the same. I would think that this would solve my problem.
While driving and applying the brakes there is a loud noise and the front brakes pads are gone completely and the rotors are in bad shape. Contacted the manufacturer and they won't fix the vehicle unless the consumer pays for the repairs.
Front brakes are wearing out prematurely, causing loss of brakes. Techincal service bulletin for defect. The rear brake shoes have the incorrect wheel cylinder installed by the manufacturer. This forces the front disc brakes to do all the braking for the vehicle.
Front end misalignment. In addition, rear axle seals/axle bearings/steering drag:link/front brake calipers/rotors and pads/rear brake shoes and drums and rear brake cylinders and brake vacuum booster failed/replaced.
When applying the ABS brakes the pedal will intermttently travel to the floor, causing extended stopping distance which nearly caused a collision. Also, dealer replaced calipers/rotors and master cylinder.
When appying the ABS brakes, the vehicle pulls to the right and left sides. Consumr states at 12,000 miles there was extensive brake pad wear on front brakes, consumer contacted manufacturer and was advised they were aware of the braking problems.
A D V E R T I S E M E N T S
- Albuquerque, NM, USA