3.0

definitely annoying
Crashes / Fires:
0 / 0
Injuries / Deaths:
0 / 0
Average Mileage:
45,600 miles

About These NHTSA Complaints:

This data is from the NHTSA — the US gov't agency tasked with vehicle safety. Complaints are spread across multiple & redundant categories, & are not organized by problem.

So how do you find out what problems are occurring? For this NHTSA complaint data, the only way is to read through the comments below. Any duplicates or errors? It's not us.

2001 Ford Expedition brakes problems

brakes problem

Find something helpful? Spread the word.
Get notified about new defects, investigations, recalls & lawsuits for the 2001 Ford Expedition:

Unsubscribe any time. We don't sell/share your email.

2001 Ford Expedition Owner Comments

problem #3

Mar 252006

Expedition 4WD 8-cyl

  • Automatic transmission
  • 106,000 miles

A D V E R T I S E M E N T S

Since purchase I have traveled 80000 miles and have replaced the rotors 3 times and the pads 4 times on the front. The most current time the vehicle shakes so bad when I apply the brake that I have to alter my driving while stopping to avoid colliding with other vehicles. I have purchased the high heat rotors and ceramic pads to have the best possible parts on the vehicle and it still eats them up too often.

- Palmyra, VA, USA

problem #2

Oct 272003

(reported on)

Expedition

  • Automatic transmission
  • 30,800 miles
While driving had applied the brakes and consumer heard a loud grinding noise. Consumer took vehicle to the dealer. Was informed by dealer that both front rotors and pads needed to be replaced.

- Apopka, FL, USA

problem #1

Jun 112002

Expedition 4WD

  • Automatic transmission
  • miles
Consumer states at 15mph the spare tire located under the vehicle fell onto the ground and could have cause an accident. Cause unknown. Dealer notified.*jbthe tire carrier was replaced. Consumer stated that the ABS light intermittently illuminates. Technician found that the front sensor wiggles and there was damage to the rotor due to it being frozen on the hub. All were replaced.

- Walnut Creek, CA, USA

Not what you are looking for?