3.6

definitely annoying
Crashes / Fires:
0 / 0
Injuries / Deaths:
0 / 0
Average Mileage:
35,000 miles

About These NHTSA Complaints:

This data is from the NHTSA — the US gov't agency tasked with vehicle safety. Complaints are spread across multiple & redundant categories, & are not organized by problem.

So how do you find out what problems are occurring? For this NHTSA complaint data, the only way is to read through the comments below. Any duplicates or errors? It's not us.

1997 GMC Jimmy drivetrain problems

drivetrain problem

Find something helpful? Spread the word.
Get notified about new defects, investigations, recalls & lawsuits for the 1997 GMC Jimmy:

Unsubscribe any time. We don't sell/share your email.

1997 GMC Jimmy Owner Comments

problem #2

Nov 152004

Jimmy 4WD 6-cyl

  • Automatic transmission
  • 70,000 miles

A D V E R T I S E M E N T S

Transmission failure / replaced transmission - upper & lower ball joint failure / replaced upper & lower ball joints - rear window wiper failure / inoperable at this point - extremely expensive replacements with no old parts available at this point. Events leading up to failure I can only attribute to severely poor manufacturing of products, there was no operating misuse or abuse. Also other parts that have failed and have since been replaced are the: Alternator, fuel pump, fuel pressure regulator and cooling system failures.

- Prior Lake, MN, USA

problem #1

Jan 012002

Jimmy 4WD

  • Automatic transmission
  • miles
Vehicle suddenly accelerated when idiling. Dealer has been contacted, and has replaced fuel injectors. The heating system malfunctioned due to heating core failure. The A/C was not blowing warm air. There was a clicking noise from the engine area because the power steering pump was leaking fluid. The vehicle leans to the left due to torsion bar out of adjustment. Front left and right axle seals were leaking. Transmission was leaking. Back window had air leak. The rear wiper sticks due to wiper motor failure. Front end makes clunking noise due to ball joint failure. There was clunk noise when shifting into gear due to rear D-shaft and U-joint failures. The intake gasket was leaking and was replaced. The throttle sticks. The serpentine belt failed and was replaced.

- Holland, MI, USA

Search CarComplaints.com for these popular complaint phrases...

Not what you are looking for?