[ switch models ] 2003 Nissan 350Z 2003 Nissan Altima 2003 Nissan Frontier 2003 Nissan Maxima 2003 Nissan Micra 2003 Nissan Murano 2003 Nissan Xterra [ switch years ] 2008 Nissan Sentra 2007 Nissan Sentra 2006 Nissan Sentra 2005 Nissan Sentra 2004 Nissan Sentra 2002 Nissan Sentra 2001 Nissan Sentra 2000 Nissan Sentra 1999 Nissan Sentra 1998 Nissan Sentra 1997 Nissan Sentra 1996 Nissan Sentra 1995 Nissan Sentra 1994 Nissan Sentra 1993 Nissan Sentra 1992 Nissan Sentra 1990 Nissan Sentra 1989 Nissan Sentra 1988 Nissan Sentra 1986 Nissan Sentra 1984 Nissan Sentra

2003 Nissan Sentra

2003 Nissan Sentra NHTSA Recalls

There are also 5 Nissan recalls » 32 TSBs » for the Nissan Sentra.

NHTSA Campaign #06E064000 EXTERIOR LIGHTING

2003 NISSAN SENTRA -- Certain tradesonic combination lamps sold as replacement lamps for use on the above listed passenger vehicles. Combination lamps not equipped with amber side reflectors fail to conform with the requirements of Federal Motor Vehicle Safety Standard no. 108, lamps, reflective devices, and associated equipment.

Lack of amber side reflectors in the lamps will decrease lighting visibility to other drivers and may possibly result in a vehicle crash.

Tradesonic will notify owners and replace the lamps free of charge. The recall is expected to begin during July 2006. Owners may contact tradesonic at 626-934-8884. For detailed information & supporting documents, see the official NHTSA page concerning recall #06E064000 »

NHTSA Campaign #06V242000 ENGINE AND ENGINE COOLING

2003 NISSAN SENTRA -- On certain passenger vehicles equipped with a 2.5L engine, a variation in temperature occurs due to the unique location of the sensor in the engine. Under certain driving conditions, these variations in temperature can be large enough to cause a brief interruption in the signal output from the sensor.

If the interruption in the signal from the sensor is so brief that the electronic control module (ecm) logic does not have time to diagnose the condition, the engine may stop running without warning while the vehicle is driven at a low speed increasing the risk of a crash.

Dealers will reprogram the ecm free of charge. The recall began on August 21, 2006. Owners may contact Nissan at 1-800-647-7261. For detailed information & supporting documents, see the official NHTSA page concerning recall #06V242000 »

NHTSA Campaign #03V511000 ENGINE AND ENGINE COOLING

2003 NISSAN SENTRA -- On certain electric vehicles, the front suspension transverse link¿S ball joint bracket may break from stress concentration at a notch created by surface roughness and the shape of the material cut-line.

Dealers will replace the bracket on these vehicles. Owner notification began December 15, 2003. Owners should contact Nissan at 1-800-647-7261. For detailed information & supporting documents, see the official NHTSA page concerning recall #03V511000 »

NHTSA Campaign #03V455000 ENGINE AND ENGINE COOLING

2003 NISSAN SENTRA -- On certain passenger vehicles, the circuit board for the crank position sensor or cam position sensor may have an improper solder joint due to solder deformation caused by heat stress accelerated by the existence of flux residue during the soldering process.

This could cause the "service engine soon" warning light to come on, create a no start condition, cause reduced engine power, or cause the engine to stop running without warning during vehicle operation, which could result in a crash.

Dealers will replace the crank position sensors. Camshaft position sensor(s), and in some cases, the variable timing control sensor(s). Vehicles involved in a previous recall campaign, 01V357, are also included in this new campaign. The replacement sensors used in that campaign are also affected. Owner notification began on December 22, 2003. Owners should contact Nissan at 1-800-647-7261 or infiniti at 1-800-662-6200. For detailed information & supporting documents, see the official NHTSA page concerning recall #03V455000 »

NHTSA Campaign #03V477000 ELECTRICAL SYSTEM:IGNITION:MODULE

2003 NISSAN SENTRA -- On certain passenger vehicles equipped with the qg18de engine or qr25de engines, the foam material used for the interior lining of the electronic control module (ecm) box emits sulfur as it cures.

If one of the resistors inside the ecm has a crack on the surface coating, the gas may cause corrosion of the resistor. This could cause the malfunction indicator light to come on, poor drivability (idle instability, poor accelerator), or the engine to stop running during vehicle operation, which could result in a crash.

Dealers will remove the inside lining material from the ecm box. Owner notification began on December 22, 2003. Owners should contact Nissan at 1-800-647-7261. For detailed information & supporting documents, see the official NHTSA page concerning recall #03V477000 »