Print this page


definitely annoying
Crashes / Fires:
0 / 0
Injuries / Deaths:
0 / 0
Average Mileage:
43,333 miles

About These NHTSA Complaints:

This data is from the NHTSA — the US gov't agency tasked with vehicle safety. Complaints are spread across multiple & redundant categories, & are not organized by problem.

So how do you find out what problems are occurring? For this NHTSA complaint data, the only way is to read through the comments below. Any duplicates or errors? It's not us.

2000 Chevrolet S-10 Pickup brakes problems

brakes problem

Find something helpful? Spread the word.
Get notified about new defects, investigations, recalls & lawsuits for the 2000 Chevrolet S-10 Pickup:

Unsubscribe any time. We don't sell/share your email.

2000 Chevrolet S-10 Pickup Owner Comments

problem #3

Feb 092006

S-10 Pickup 4WD 6-cyl

  • Automatic transmission
  • 78,000 miles


: the contact stated after purchasing a used vehicle that already had the ABS light illuminated, the ABS engaged at speeds of 10mph or less. The vehicle was inspected by the dealer. The entire ABS control module was replaced. Afterwards the problem continued, but no further repairs were made.

- Secor, IL, USA

problem #2

May 132005

S-10 Pickup 6-cyl

  • Automatic transmission
  • 52,000 miles
While driving at a low speed, about 5 mph, owner went to a fast food line and pushed the brakes and the pedal was stiff. There was a pulsation in the brakes, and extended stopping was required. Owner had to pull out of line to keep vehicle from hitting the car in front. The owner then pushed the brakes, and they worked just fine. The problem only occurred when the owner was going at slow speeds. The problem happened in all weather and road conditions. The owner was aware that there was a known problem with the ABS sensor, and was wondering when the recall will take place.

- Canterbury, NH, USA

problem #1

Apr 252004

S-10 Pickup

  • miles
ABS motor continues to run after engine has been shut off.

- Crystal Lake, IL, USA

Not what you are looking for?