Huge win for car owners! All TSBs to be made public. The Center for Auto Safety just made the NHTSA (US Government) make public the full text of all TSBs from now on. They are the same organization that has petitioned the NHTSA & filed lawsuits to protect car owners over exploding gas tanks & other major safety issues. Whenever you drive in your car, you are safer thanks in part to a lot of work over the years by this small but very effective consumer advocacy group.

Please take a moment & say thank you by donating $5 or whatever you can to the Center for Auto Safety.

NHTSA — Engine And Engine Cooling: Engine Problems


fairly significant
Crashes / Fires:
0 / 0
Injuries / Deaths:
0 / 0
Average Mileage:
19,500 miles

About These NHTSA Complaints:

This data is from the NHTSA — the US gov't agency tasked with vehicle safety. Complaints are spread across multiple & redundant categories, & are not organized by problem.

So how do you find out what problems are occurring? For this NHTSA complaint data, the only way is to read through the comments below. Any duplicates or errors? It's not us.

2007 Saab 9-3 engine problems

engine problem

Find something helpful? Spread the word.
Get notified about new defects, investigations, recalls & lawsuits for the 2007 Saab 9-3:

Unsubscribe any time. We don't sell/share your email.

2007 Saab 9-3 Owner Comments

problem #2

Jun 012010

9-3 4-cyl

  • 39,000 miles


2007 Saab 9-3 the vehicle stalls during hot and cold weather. Sometimes the vehicle runs "rough" the vehicle has then stalled in the middle of an intersection. The vehicle has been to the dealer six times for this problem. Saab usa has been made aware of this problem and I advised them I want them to buy the vehicle back. The vehicle is still under it's factory warranty.

- Colorado, CO, USA

problem #1

Jan 052008


  • miles
2007, 2.0T Saab 93 engine stalling start engine, hot or cold, place gear selector in forward or reverse, the engine will stall out, but will immediately re-start. Car has been back to dealer twice for re-programming of ECM, but engine still stalls.

- Danvers, MA, USA

Not what you are looking for?