2007 Subaru Outback. Consumer writes in regards to brake failure. The consumer stated the right rear brake line corroded and failed while driving. The dealer was contacted.

- Irvine, CA, USA

Stepped on the brakes while on the highway and they went to the floor. Fortunately I was able to grab the emergency brake and Dodge into the next lane otherwise I would have slammed into the car in front of me, causing unknown damage/injury. I used the parking break and manual shifting option to limp it back to my house a few miles away. I walked around the vehicle and found a puddle of brake fluid dripping onto the ground at the passenger side rear wheel. Upon further inspection, I found a metal brake line was leaking fluid where it was clamped to the vehicle body. As I was looking for the part/information on it, I came across a known recall for this problem. I contacted Subaru and they stated that the recall had already been done on 8/8/2014. Part of the recall stated that if it wasn't leaking at the time, they were to spray it with an anti-corrosion of some sort and call it good. Apparently that's what happened to mine because the lines are very rusty and corroded. Now they want to charge thousands of dollars to have the repair completed. If this is a known safety issue and the results of failure are possibly crashing at high speeds when the brake line ruptures, how are they able to spray an anti-corrosion fluid over top of rust and wash their hands of such a potentially dangerous/fatal known problem? recall #wqk-47, 14V311000, and wqg-43

- Summerville, SC, USA

Brakes failed on a city street, approaching highway on-ramp - car being driven by a 17 year old new driver - thankfully no collision or damage to person or property occurred. After inspection, rear brake line failed due to corrosion/perforation at 2-2 way connector at 176K miles after two previous recalls were supposedly executed. Dates of note: ' 2007 - vehicle sold by anchor Subaru, North smithfield, ri to original owner (not me) ' June 11, 2013 - recall wqg-43 performed with first owner at anchor Subaru ' spray wax applied ' car has 132K miles ' August 13, 2014 - recall wqk-47 performed with first owner at anchor Subaru ' spray wax applied a second time ' car has 152K miles ' May 7, 2017 ' vehicle re-sold to 2nd owner (me), ' car has 166K miles ' March 12, 2019 ' vehicle brakes fail ' car has 176K miles makes no sense how, in a span of only 24K miles from when the recall work was performed the second time at 152K miles, until the brake failure at 176K miles, the twice-applied wax 'remedy' performed in the recall actions wore off completely, and, the brake line completed corroded and failed. This does not seem possible nor probable, and, if it is possible, then the 'remedy' that was provided by Subaru was unsuitable, or, the dealership incorrectly applied the material that was supposed to prevent the corrosion from happening. I have no proof that this work was actually performed. I believe that the spray-on wax was not correctly applied in neither method nor quantity on my vehicle. Anchor Subaru would not cover this under the recall. Paid my own mechanic to fix the issue. Sent registered letters to Subaru of America and to the 3 owners of the dealership over a month ago and none have responded to my concerns.

- Warwick, RI, USA

Brake line broke on the passenger side under the rear door. I could see the fluid coming out through a cover of some kind that I think is to protect the fuel tank. I was driving and needed to stop and the pedal went suddenly to the floor and I went past where I tried to stop.

- Sudbury, VT, USA