I purchased a used 2000 Oldsmobile Bravada in June 2008. The vehicle passed state required inspection with no issues. On 9/19/08 the stop lamps unexpectedly blew all four bulbs and the stop lamps now do not work at all even with new bulbs installed. Upon doing internet search for causes and repair solutions, I found that there had been a recall in 2001 regarding stop lamp/hazard flasher switch failures. I called a local dealer and they informed me that the hazard flasher switch had been replaced during the first recall and they could not do the repair again, however, I also found that a new recall had been issued in 2008 for the same issue. I have replaced the bulbs and stop lamp switch with no resolution to the failure of the stop lamps. The dealership says it will cost me $100 to get the wiring checked and I will be responsible for the cost of repairs. If this is an ongoing issue with the lighting I believe that the testing should be at no cost. Failure of the stop lamps puts my family at serious risk of injury if vehicles behind me are not able to know that I am stopping. The highmount lights, flashers, back up lights and turn signals are not affected...only the lower stop lamps. I also have an issue with multi function turn signal switch being loose on steering column. I have purchased the part but have not had it installed as of the date of this letter. When engaging the switch to make a right turn the windshield wipers come on. This only happens when making a right turn.

- Hudson, NH, USA

The consumer experienced the same problem as stated in recall 01V364000 concerning multi function switch. The dealership would not repair the problem free of charge because the VIN was not included.

- Covington, VA, USA