TSB Document:

Affected Component: FORWARD COLLISION AVOIDANCE

Summary
2018-2019 LEAF; REPLACING OR ALIGNING DISTANCE SENSOR (ICC SENSOR) BRACKET OR CHARGE PORT LID SERVICE INFORMATION If a distance sensor (ICC sensor) bracket is removed or replaced (see Figure 1 on the next page): - Take care when handling the distance sensor bracket. It can be damaged if dropped. - Do not bend the distance sensor bracket to adjust radar alignment. NOTE: If the distance sensor is difficult to align, confirm the bracket is not bent by comparing it to a known good vehicle. - Always perform an ICC Sensor Alignment (Radar Alignment Procedure) whenever the distance sensor bracket is removed or replaced. - To locate the Radar Alignment Procedure in the Electronic Service Manual (ESM), select the "Trouble Diagnosis" section and enter ICC Sensor Alignment into the Title Search field. If a charge port lid is removed or replaced: - Do not bend the charge port lid frame to adjust (Figure 2). - Do not bend any of the components attached to the charge port bracket (Figure 2). - To locate the Charge Port Lid Adjustment Specs and Procedure in the ESM, select the ?Inspection, Removal, and Installation? section and enter Charge Port Lid Assembly into the Title Search field. - Always perform an ICC Sensor Alignment (Radar Alignment Procedure) whenever any of the components called out in Figure 2 are removed or replaced. - To locate the Radar Alignment Procedure in the Electronic Service Manual (ESM), select the "Trouble Diagnosis" section and enter ICC Sensor Alignment into the Title Search field.

Click a tab for more information.

Date Published
DEC 18, 2018
NHTSA TSB #
10152985
Find something helpful? Spread the word.

Become a Fan & Spread the Word