Brake pedal goes all the way to the floor and there is no brakes, the truck won't stop.

- Gilroy, CA, USA

No summary listed for above vehicle.

- Corryton, TN, USA

Original brakes, drums and pads on rear drivers side replaced at 24,000 mi. Failed again same problem at 26,000. Original transmition and torque converter replaced at 21,000

- Norco, CA, USA

Braking system malfunctioned, causing the brake rotors to fail5 times which may result in extended stopping distance.

- Smithsburg, MD, USA

While making a stop brake pedal would travel to the floorboard, causing extended stopping distance. Dealer has been contacted.

- Pottsboro, TX, USA

ABS brake failure.

- Gilroy, CA, USA

ABS brakes; when applying brakes in panic stops, the pedal goes to the floor and brakes fail to stop vehicle.

- Plantation, FL, USA

Continuous repairs and failures on the anti lock brake system, failures cause vibration and lock up.

- Mojave, CA, USA

When brakes are applied in a panic stop, the front brakes lock up and the back brakes do nothing, causing the vehicle to collide into another. The dealer has been notified.

- Olathe, KS, USA

When applying the brakes you get a metal to metal grinding noise. Has had repaired 2 times.

- Jacksonville, NC, USA

During operation, the brake pedal goes to the floor when brakes are applied. The vehicle will not stop.

- Middlebury, VT, USA

Brakes failed.

- Big Sky, MT, USA

While driving, experienced brake failure, when made attempt to slow/stop brakesact seem ineffective to stop, pedal went to floor, vehicle rolled forward.

- Hathaway Pin, CA, USA

ABS, brake failure leaking wheel cylinder, causing total loss of effectiveness, impact 12:00 speed 5 mph

- West Fargo, ND, USA

ABS, brake failure leaking wheel cylinder, causing total loss of effectiveness, impact 12:00 speed 5 mph

- West Fargo, ND, USA

Under an emergency stop the ABS anti-lock brake slows truck down doesn't stop.

- Belvidere, NJ, USA

ABS, after driving for few seconds intermittently loss of brake effectiveness, if driving a long distance when applying brakes loss of pressure.

- Mcrae , AR, USA

ABS, brake failure, loss of effectiveness after repeatly applying brakes, in for repair every 1,000 miles.

- Scappoose , OR, USA