2014 Chrysler 300 AC / heater problems: not regulating heat properly on auto setting

Not Regulating Heat Properly On Auto Setting

2014 Chrysler 300

This problem may be covered under warranty. Ask your Chrysler dealer.

6.0

fairly significant
Typical Repair Cost:
No data
Average Mileage:
86,500 miles
Total Complaints:
2 complaints

Most Common Solutions:

  1. not sure (1 reports)
  2. replaced actuator (1 reports)
Get free help with your lemon!
close ad
2014 Chrysler 300 AC / heater problems

AC / heater problem

Find something helpful? Spread the word.
Get notified about new defects, investigations, recalls & lawsuits for the 2014 Chrysler 300:

Unsubscribe any time. We don't sell/share your email.

2014 Chrysler 300 Owner Comments

problem #2

Nov 082017

300 S V6

  • Automatic transmission
  • 141,000 miles

A D V E R T I S E M E N T S

When A/C or heat is on the 'auto' setting all of a sudden hot air comes out all vents to a point that it feel like a fire. The only thing to be done is turn the car system off and wait. Very difficult to drive when this happen that's how hot it gets.

- Marvin R., Pittsburgh, PA, US

problem #1

Sep 012016

300 S 3.6L V6

  • Automatic transmission
  • 32,000 miles

After doing a software update which was covered under the standard warranty, I began having issues with the heating and cooling not regulating properly. For example, I would have my heat set at 68 degrees and on the "auto" setting, however, after about ten minutes of driving, the heat would be on full blast coming out of all vents. The only way I was able to stop it was to turn on "Max A/C" for a few minutes, then go back to "Auto". After two attempts of fixing the issue at the dealership, they found that the actuator was not working and they replaced it. I have not had any issues with it since.

- Justin C., Bozeman, MT, US

Not what you are looking for?