NHTSA — Vehicle Speed Control: Cruise Control Problems


definitely annoying
Crashes / Fires:
0 / 0
Injuries / Deaths:
0 / 0
Average Mileage:
34,177 miles

About These NHTSA Complaints:

This data is from the NHTSA — the US gov't agency tasked with vehicle safety. Complaints are spread across multiple & redundant categories, & are not organized by problem.

So how do you find out what problems are occurring? For this NHTSA complaint data, the only way is to read through the comments below. Any duplicates or errors? It's not us.

2005 Mercury Mountaineer engine problems

engine problem

Find something helpful? Spread the word.
Get notified about new defects, investigations, recalls & lawsuits for the 2005 Mercury Mountaineer:

Unsubscribe any time. We don't sell/share your email.

2005 Mercury Mountaineer Owner Comments

problem #1

Feb 112008

Mountaineer 6-cyl

  • Automatic transmission
  • 34,177 miles


The contact owns a 2005 Mercury Mountaineer. On the day the vehicle was purchased, the contact noticed fluid leaking onto her garage floor. She returned to the dealer and was informed that the pinion seal needed to be replaced, and repairs were made. While traveling 45 mph, the contact attempted to set the cruise control and the vehicle shut off in the middle of the road. She was able to pull over to the shoulder and restart the vehicle to drive home. After work one evening, she was unable to start the vehicle. After 20 minutes, her father arrived and was able to forcefully start the vehicle. The contact returned to the dealer the following day, but they could not duplicate the failure with the cruise control or the stalling. On June 16, 2008, she took the vehicle to the dealer and they replaced a fuse. Upon further inspection, they identified a bushing that needed to be replaced as well. All of these failures occurred within four months of purchasing the vehicle and with less then 4,000 miles placed on the vehicle by the contact. The failure mileage was 34,177 and current mileage was 37,600. Updated 07/15/08 when the consumer started the vehicle, the power seats and power locks failed to work. The consumer returned to the dealer and they replaced the driver side motor. The sway bar bushings were replaced. Updated 07/15/08

- Saxondurg, PA, USA

Not what you are looking for?