Taillight Assembly Studs Break

7.0

pretty bad
Typical Repair Cost:
$314.00
Average Mileage:
72,500 miles
Total Complaints:
2 complaints

Most Common Solutions:

  1. not sure (1 reports)
  2. use metal studs to support the assembly (1 reports)
1995 Pontiac Bonneville lights problems

lights problem

Find something helpful? Spread the word.
Get notified about new defects, investigations, recalls & lawsuits for the 1995 Pontiac Bonneville:

Unsubscribe any time. We don't sell/share your email.

1995 Pontiac Bonneville Owner Comments

problem #2

Jan 022007

(reported on)

Bonneville SE V6

  • Automatic transmission
  • 100,000 miles

A D V E R T I S E M E N T S

The tail light assembly on my 1995 Pontiac Bonneville SSE is supported by 3 plastic studs that are part of the tail light assembly. I believe thermal stress between the plastic studs and the metal housing plate result in failure of the mounting studs and the three studs fail leave the assembly hanging by the wiring. I had both rear tail light assemblies fail in the last 5 years. There is no sign of physical contact and both appeared after exposure to hot summer sunlight.

But the "good" news is that a new assembly only cost $300!

- , Duluth, GA, US

problem #1

Apr 162006

(reported on)

Bonneville

  • 45,000 miles

tail lights assembly (lens housing) keep breaking off at the studs causing it to fall out of the car. this problems needs to be corrected

- , Folsom, PA, US

Not what you are looking for?