2006 GTO Clutch actuator (Slave cylinder). The clutch slave cylinder is located inside the bell housing of the transmission. Unlike a traditional slave cylinder, which is found outside the bell housing, the GTO slave cylinder requires the removal of the transmission in order to replace it.

In order to remove the transmission, a mechanic must first remove the entire exhaust system, 2-piece drive shaft assy., transmission shifter mechanism and console inside the car, then the transmission itself.

The bleed nipple for the slave cylinder is located at the top of the bell housing (inside a small opening on the bell housing). It can not be seen without a mirror and there is no way to attach a bleed tube to relieve the fluid. So, in order to bleed the new slave cylinder, the bleed screw must be opened, which allows clutch fluid to run down the inside of the bell housing, and then onto the floor. Very messy, and potentially troublesome, if the fluid gets on to the clutch itself.

The answer is a remote bleed attachment, which is available from the aftermarket, but which dealers will not install.

This is an unbelievable amount of work and money for a car with 7200 miles. A very weak link for an otherwise great driving vehicle.

Thank you.,