- May 22: NHTSA Closes 'Audit Query' Into Chrysler Parts Restrictions investigations | 4 days ago
- May 18: Fiat Chrysler Recalls 580,000 Cars and SUVs in 2 Recalls recalls | 8 days ago
- May 18: Chrysler Recalls 2,185 Trailer Tow Light Modules recalls | 8 days ago
- May 15: Chrysler Recalls Jeep Grand Cherokees For Locked Gear Shifters recalls | 11 days ago
- May 8: Lawsuit Alleges Jeep Recall Created 4-Wheel-Drive Problems news | 18 days ago
1993 Chrysler Concorde
4 Recalls & Safety Reports
Recall List for the 1993 Chrysler Concorde
Official recalls have been issued for the 1993 Chrysler Concorde by the NHTSA. The complete details of all recalls are listed below, along with what they cover and the recommended solutions.
Recalls don't cost you anything to get fixed, but most are time-limited, so if your car is affected you should call your local Chrysler service department immediately!
If you have questions about a recall, write down your VIN & then call Chrysler customer service.
1993 Chrysler Concorde POWER TRAIN:AUTOMATIC TRANSMISSION:LEVER AND LINKAGE:FLOOR SHIFT NHTSA Campaign #04V021000
Summary: On certain passenger vehicles, the floor shifter ignition-park interlock may fail and allow the shifter to be moved out of the park position with the key removed. An inoperative interlock may also allow the key to be removed when the shifter has not been placed in the park position.
Consequence: Either circumstance may result in the vehicle rolling away without warning.
Actions: Dealers will install a new load-limiting push rod into the floor shifter lever of the affected vehicles. Owner notification began on June 14, 2004. Owners should contact DaimlerChrysler at 1-800-853-1403. For detailed information & supporting documents, see the official NHTSA page concerning recall #04V021000 »
1993 Chrysler Concorde SUSPENSION:FRONT:CONTROL ARM:LOWER ARM NHTSA Campaign #99V215000
Summary: Vehicle description: Passenger vehicles. The lower control arm attaching brackets can crack due to fatigue and separate from the engine cradle.
Consequence: If this occurs, the transmission half-shaft could pull out of the transaxle and result in loss of power.
Actions: Dealers will reinforce the engine cradle at the point where the lower control arm attaches to it. For detailed information & supporting documents, see the official NHTSA page concerning recall #99V215000 »
1993 Chrysler Concorde FUEL SYSTEM, GASOLINE:FUEL INJECTION SYSTEM NHTSA Campaign #98V184000
Summary: Vehicle description: Passenger vehicles built with 3.5L engines. The fuel injection delivery system can leak fuel from some of the sealing O-rings or from hair line cracks in the thermoset fuel injection rail.
Consequence: Fuel leakage in the presence of an ignition source can result in a fire.
Actions: Dealers will replace the fuel rail O-rings and reinforce the outlet (passenger) side fuel rail. Vehicles showing fuel leakage on the outlet fuel rail must have the outlet rail replaced which includes changing the upper and lower injector O-rings. However, if a vehicle is leaking fuel from the O-rings or from a cracked fuel line, the vehicle should be taken into a dealer to have this repaired as soon as possible. For detailed information & supporting documents, see the official NHTSA page concerning recall #98V184000 »
1993 Chrysler Concorde FUEL SYSTEM, GASOLINE:DELIVERY NHTSA Campaign #98V130000
Summary: Vehicle description: Passenger vehicles built with 3.3L engines. The 'O-rings' used to seal the interface of the fuel injector rail supply, return and cross over tubes are not as robust as those used in later model years. Deterioration of the 'O-rings' can cause fuel leakage.
Consequence: In the presence of an ignition source, fuel leakage in the engine compartment could result in a fire.
Actions: Dealers will replace the engine fuel rail. For detailed information & supporting documents, see the official NHTSA page concerning recall #98V130000 »