NHTSA Campaign #96V099000 SERVICE BRAKES, HYDRAULIC:ANTILOCK

JUNE 13
1996

321,000 vehicles recalled

1991 DODGE DYNASTY -- The ABS hydraulic control unit can experience excessive brake actuator piston seal wear causing pump-motor deterioration.

If this condition occurs, the ABS function could be lost and reduced power assist would be experienced during vehicle braking increasing the potential for a vehicle accident.

Dealers will test the vehicle's anti-lock brake system and repair the vehicles if necessary. Also the warranty on all ABS components will be extended to 10 years or 100,000 miles (except for the brake actuator piston assembly and the pump-motor assembly which will have a lifetime coverage). Owners will also be reimbursed for previous ABS component repair costs. For detailed information & supporting documents, see the official NHTSA page concerning recall #96V099000 »

NHTSA Campaign #91V191000 SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:HOSES, LINES/PIPING, AND FITTINGS

NOVEMBER 01
1991

80,000 vehicles recalled

1991 DODGE DYNASTY -- The anti-lock brake system high pressure hose may leak or detach at its crimped end fitting resulting in the discharge of hydraulic fluid.

Fluid discharge eventually causes the loss of both theanti-lock brake system and hydraulic assist for the brake system, resulting inincreased likelihood of brake lockup and increased stopping distances, whichcould result in a vehicle accident.

Replace the ABS high pressure hose with a hose of different design and construction. For detailed information & supporting documents, see the official NHTSA page concerning recall #91V191000 »

NHTSA Campaign #91V004000 VISIBILITY:DEFROSTER/DEFOGGER SYSTEM:WINDSHIELD:BLOWER

OCTOBER 02
1991

125,000 vehicles recalled

1991 DODGE DYNASTY -- Water leaking under windshield cowl in area above heater blower motor resistor block results in corrosion of the resistor terminals.

Corrosion of the resistor terminals increases electricalresistance, leading to overheating and possble ignition of the wiring connectorsand insulation, causing a fire in the cowl area.

The blower motor resistor block will be replaced, and a mastic patch applied to seal the cowl against water entry. Damaged wire connectors will be replaced. For detailed information & supporting documents, see the official NHTSA page concerning recall #91V004000 »

NHTSA Campaign #91V122000 SEAT BELTS:FRONT:ANCHORAGE

JULY 11
1991

130,000 vehicles recalled

1991 DODGE DYNASTY -- Front outboard safety belt may become difficult to latch and or unlatch due to a webbing stiffener entering the buckle housing and dislodging the buckle latch guide.

Latch may open during accident or sudden stop, exposingseat occupant to increased risk of injury.

Replace buckle latch engagement. For detailed information & supporting documents, see the official NHTSA page concerning recall #91V122000 »

NHTSA Campaign #90V162000 SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:DISC:CALIPER

SEPTEMBER 04
1990

18,000 vehicles recalled

1991 DODGE DYNASTY -- Front disc brake caliper guide pin bolts may not have been adequately torqued and could loosen.

This could cause reduced braking effectiveness and couldresult in an accident.

Properly torque front brake caliper guide pin bolts to 250 pounds. For detailed information & supporting documents, see the official NHTSA page concerning recall #90V162000 »