- September 14: Honda Argues Unintended Braking Lawsuit Should Be Tossed news | 5 days ago
- August 24: Audi e-tron Quattro SUVs Recalled to Replace Brake Boosters recalls | 26 days ago
- August 16: Volkswagen Suction Jet Pump Recall Precedes Class Action Lawsuit news | 34 days ago
- July 29: Audi Alternator Class Action Lawsuit Settlement Nears news | 52 days ago
- July 7: Chrysler Uconnect Lawsuit Says Infotainment Systems Have Problems news | 74 days ago
Audi TSB #A961379 2035047-
2014 Audi Q5
TSB Document:
Affected Component: LANE DEPARTURE: BLIND SPOT DETECTION
- Summary
- Supersedes Technical Service Bulletin Group 96 number 13-77 dated September 23, 2013. Audi Lane Change Assistant deactivates or is sporadically inoperative when the vehicle is driven in slow-moving stop-and-go traffic, especially on roads with multiple lanes.The message "Audi side assist unavailable: Sensors blocked" appears in the driver information system. The system is able to be activated approximately ten minutes after the traffic condition is removed, or after an ignition cycle. DTCs are stored in the Lane Change Assistance control module. Audi Lane Change Assistant can be activated without issue. No obstructions can be found on the outside or inside of bumper. No re-work of the bumper can be found. The control module mounting brackets are securely fastened to the lower rear bumper, and no damage is found on the inside or on the outside rear bumper area. The control module mounting brackets are not broken or loose. In certain normal driving conditions, the Audi Side Assist system can automatically deactivate, and the driver information display shows the "sensors blocked" message. This is normal, as the nature of certain driving conditions can make it difficult for the Audi Side Assist system to track vehicles.
Click a tab for more information.