pretty bad
Crashes / Fires:
0 / 0
Injuries / Deaths:
0 / 0
Average Mileage:
4,621 miles

About These NHTSA Complaints:

This data is from the NHTSA — the US gov't agency tasked with vehicle safety. Complaints are spread across multiple & redundant categories, & are not organized by problem.

So how do you find out what problems are occurring? For this NHTSA complaint data, the only way is to read through the comments below. Any duplicates or errors? It's not us.

2020 Hyundai Palisade electrical problems

electrical problem

Find something helpful? Spread the word.
Get notified about new defects, investigations, recalls & lawsuits for the 2020 Hyundai Palisade:

Unsubscribe any time. We don't sell/share your email.

2020 Hyundai Palisade Owner Comments

problem #6

Apr 022021


  • 15,000 miles


While driving on highway 290 West to fredicksburg, Texas on April 2,2021, speed limit varies from 50-60 mph, the vehicle just stopped, all systems were out, message on the screen said "take to service, when convenient". it was very scary as the vehicles from behind were honking and I could not get the car to the side. It could have been a major accident with fatalities.

- Austin, TX, USA

problem #5

Jul 292020


  • 128 miles
The contact owns a 2020 Hyundai Palisade. The contact stated that the vehicle was recently purchased from global Hyundai (1099 us-22, North plainfield, NJ 07060). The contact stated that while in reverse, there was an unknown flash on the navigation system screen before the screen became inoperable. Several seconds later, the screen resumed normal operation without driver input. Additionally, the back over prevention screen was also inoperable. The vehicle was not taken to the dealer to be diagnosed. The manufacturer was not made aware of the failure. The failure mileage was 128.

- Rahway, NJ, USA

problem #4

May 302020

Palisade 6-cyl

  • 2,100 miles
2100 miles and the digital and analog speed odometer both stopped working. The gas gauge also acted erratic. It wasn't showing the gas as full but the tank had just been completely filled (picture has example of both). Dealership unplugged the battery and reset the vehicle to factory settings and fixed the problem. I work for a car electrical component manufacturing supplier and it is believed this is caused by software within the instrument cluster because the speed odometer and the fuel gas aren't connected within the vehicle.

- Maryville, TN, USA

problem #3

Oct 302019

Palisade 6-cyl

  • 7,500 miles


Main touch screen will not respond when it is cold outside. We were at our home in Wisconsin until Oct 30, 2019 and it would not respond to touch ( navigation would respond to voice only). November 4 until April 4 2020 we were in Arizona ( temp in the 65-75 range)and had no problems. April 4 till present it will not work in Wisconsin (temp in the 40-50F range). Also screen gets very warm almost hot to touch when it will not respond to touch. Hopping it will not start fire before it gets fixed.

- Wisconsin Dells, WI, USA

problem #2

Jan 022020


  • 500 miles
1) first issue was a cracked windshield within the first 500 miles. Driving down the highway, no foreign object, suddenly a crack started to form. 2) second issue is a blind spot warning system alert when no cars are present. 3) third issue is automatic wiper that suddenly come on when no rain or debris are present. 4) fourth issue, but far from the last, is the ongoing wind noise problem that Hyundai can’T seem to solve. It is so loud on the highway that the drone is louder than the radio. I’ve measured this as high as 86db.

- Oak Ridge, NC, USA

problem #1

Dec 142019


  • 2,500 miles
We purchased our 2020 Hyundai Palisade limited six weeks ago. Currently has 3000 miles. The blind spot collision warning system (bscw) has a malfunction and stops working after driving a few miles on both highway and city/country roads. There are no cars or trees/obstacles around the car when it deactivates. Restarting the car resets the bscw system, but it malfunctions again in a few miles. When the system is deactivated, we cannot turn off blind spot active assist--it gives a controller error. We tried shutting off the bscw system indicator in the heads-up display. That does not fix the problem

- Pinehurst, NC, USA

Not what you are looking for?