- December 31: Nissan Used Uncertified Inspectors For Decades news | 16 days ago
- December 28: Certain Automakers Falling Behind With Automatic Emergency Braking news | 19 days ago
- December 24: Mazda B-Series Trucks Recalled Again to Replace Airbags recalls | 23 days ago
- November 30: Mazda Recalls Mazda3 Cars At Risk of Stalling recalls | 47 days ago
- November 30: Mazda Recalls 2017 CX-5 SUVs to Fix Trailer Hitch Harnesses recalls | 47 days ago
2006 Mazda Tribute
3 Recalls & Safety Reports
Recall List for the 2006 Mazda Tribute
Official recalls have been issued for the 2006 Mazda Tribute by the NHTSA. The complete details of all recalls are listed below, along with what they cover and the recommended solutions.
Recalls don't cost you anything to get fixed, but most are time-limited, so if your car is affected you should call your local Mazda service department immediately!
If you have questions about a recall, write down your VIN & then call Mazda customer service.
2006 Mazda Tribute SUSPENSION:FRONT:WHEEL BEARING NHTSA Campaign #15E045000
Summary: The Timken Company (Timken) is recalling certain aftermarket front wheel bearings, part number 510072, sold from January 22, 2015, to May 21, 2015, to be used as service parts on 2001-2012 Ford Escape, 2001-2011 Mazda Tribute, and 2005-2011 Mercury Mariner vehicles. The affected wheel bearings have incorrect dimensions of a 42mm bore, 76mm outer dimension, and 39mm width, instead of a 42mm bore, 78mm outer dimension and a 45mm width.
Consequence: Use of an incorrectly sized wheel bearing can adversely affect the braking and steering of the vehicle, increasing the risk of a crash.
Actions: Timken has begun notifying distributors who will offer purchasers replacement wheel bearings, free of charge. The recall began on May 21, 2015. Owners may contact Timken customer service at 1-866-984-6536. For detailed information & supporting documents, see the official NHTSA page concerning recall #15E045000 »
2006 Mazda Tribute ENGINE AND ENGINE COOLING, VEHICLE SPEED CONTROL:CABLES NHTSA Campaign #12V357000
Summary: Mazda is recalling certain model year 2001 through 2006, and 2008, Tribute vehicles equipped with 3.0L V6 engines and speed control. Inadequate clearance between the engine cover and the speed control cable connector could result in a stuck throttle when the accelerator pedal is fully or almost-fully depressed. This risk exists regardless of whether or not speed control (cruise control) is used.
Consequence: A stuck throttle may result in very high vehicle speeds and make it difficult to stop or slow the vehicle, which could cause a crash, serious injury or death.
Actions: Mazda will notify owners, and dealers will repair the vehicles by increasing the engine cover clearance, free of charge. Remedy parts are now available. The safety recall began on September 13, 2012. Owners may contact Mazda Customer Assistance Center at 1-800-222-5500, option #6. For detailed information & supporting documents, see the official NHTSA page concerning recall #12V357000 »
2006 Mazda Tribute VISIBILITY:WINDSHIELD WIPER/WASHER:MOTOR NHTSA Campaign #05V525000
Summary: On certain trucks and sport utility vehicles, the windshield wiper motor may have been produced without grease applied to the output shaft gear.
Consequence: After a period of continuous use on the high speed setting, lack of grease on the output shaft gear may cause the gear teeth to distort or fracture during operation resulting in the loss of wiper function. Inoperative wipers under inclement weather conditions could cause a crash due to impaired visibility.
Actions: Dealers will inspect the wiper motor for the presence of grease and grease the wiper motor gears if necessary. The recall began on November 28, 2005. Owners may contact Mazda at 1-800-222-5500. For detailed information & supporting documents, see the official NHTSA page concerning recall #05V525000 »