1994 Chrysler New Yorker
1994 Chrysler New Yorker NHTSA Recalls
There are also 3 Chrysler recalls » 11 defect investigations » 62 TSBs » for the Chrysler New Yorker.
NHTSA Campaign #99V215000 SUSPENSION:FRONT:CONTROL ARM:LOWER ARM
402,830 vehicles recalled
1994 CHRYSLER NEW YORKER -- Vehicle description: Passenger vehicles. The lower control arm attaching brackets can crack due to fatigue and separate from the engine cradle.
If this occurs, the transmission half-shaft could pull out of the transaxle and result in loss of power.
Dealers will reinforce the engine cradle at the point where the lower control arm attaches to it. For detailed information & supporting documents, see the official NHTSA page concerning recall #99V215000 »
NHTSA Campaign #98V184000 FUEL SYSTEM, GASOLINE:FUEL INJECTION SYSTEM
722,600 vehicles recalled
1994 CHRYSLER NEW YORKER -- Vehicle description: Passenger vehicles built with 3.5L engines. The fuel injection delivery system can leak fuel from some of the sealing O-rings or from hair line cracks in the thermoset fuel injection rail.
Fuel leakage in the presence of an ignition source can result in a fire.
Dealers will replace the fuel rail O-rings and reinforce the outlet (passenger) side fuel rail. Vehicles showing fuel leakage on the outlet fuel rail must have the outlet rail replaced which includes changing the upper and lower injector O-rings. However, if a vehicle is leaking fuel from the O-rings or from a cracked fuel line, the vehicle should be taken into a dealer to have this repaired as soon as possible. For detailed information & supporting documents, see the official NHTSA page concerning recall #98V184000 »
NHTSA Campaign #94V024000 ELECTRICAL SYSTEM:WIRING
110,000 vehicles recalled
1994 CHRYSLER NEW YORKER -- The right steering tie rod can rub through the automatic transmission wiring harness causing a short circuit which results in electrical system malfunctions including engine stalling and an inoperative park/starter interlock system.
Electrical system malfunction causing stalling while in motion or an inoperative park/starter interlock system, which allows engine start while the transmission is not in the park position, may result in an accident.
Install a revised wiring harness bracket and a plastic convoluted sleeve to protect the transmission wiring harness. For detailed information & supporting documents, see the official NHTSA page concerning recall #94V024000 »