This data is from the NHTSA — the US gov't agency tasked with vehicle safety. Complaints are spread across multiple & redundant categories, & are not organized by problem.
So how do you find out what problems are occurring? For this NHTSA complaint data, the only way is to read through the comments below. Any duplicates or errors? It's not us.
The vehicle is experienced the same defect with the automatic transmission cooling lines as stated in recall 97 V 084 000, but the consumer vehicle was not included in the recall due to VIN.
While driving and when brakes were applied they did not hold, pedal went all the way to the floor, consumer stated the vehicle coasted through a red light through a busy intersection, this was caused by a hole in the brake line, which was the result of the way the brake line was assembled.. consumer stated the 4X4 did not work, the tire blew out, there was a water leak and the carpet had to be replaced twice, the rear window was replaced, the rear brakes never worked, the radio was inoperative, the hood light flickered while driving, and also vehicle experienced transmission problems.
While driving 20mph, and shifting gears it would stick in first gear. This caused the transmission to slip and not shift properly. Transmission has bee replaced 3 times, but problem still exists. Please add VIN.
- Harrison, TN, USA
Search CarComplaints.com for these popular complaint phrases...
Transmission was slipping and would not go into gear. Consumer had transmission rebuilt, but did not remedy problem. Transmission was still slipping until it finally went out. Contacted dealer. Please add further information.
Consumer was traveling uphill at approximately 65 mph when vehicle suddenly lost 5th gear, and began losing speed. Consumer stated that there was a nut that held transmission in 5th gear, but this nut had fallen off. Please provide any additional information/attachments.
Premature tranmission failure caused by direct clutch pack drum machining defect resulting in outer lip seal failure. This will cause the transmission to loose 3rd gear. Chrysler does not acknowledge this common problem that ocurs with this transmissions. The aftermarket transmission rebuild kit companies have all intorduced improved(larger thicker stronger) direct clutchdrum outer lip seals to help address a problem Chrysler says does not exist.
Premature tranmission failure caused by direct clutch pack drum machining defect resulting in outer lip seal failure. This will cause the transmission to loose 3rd gear. Chrysler does not acknowledge this common problem that ocurs with this transmissions. The aftermarket transmission rebuild kit companies have all intorduced improved(larger thicker stronger) direct clutchdrum outer lip seals to help address a problem Chrysler says does not exist.
97V068000/brakes: Vehicle been experiencing ongoing problem with brake failure. Vehicle been to dealer shop on four or more occasions, and condition still is unresolved. Transmission trouble has also occurred several times.
When vehicle is on an incline and placed into reverse, vehicle will coast foward until the accelerator is applied. When placed in reverse on level ground, it will not react at all when the accelerator is applied. Dealer has been contacted.
Transmission fluid temperature can exceed the melting point of the material used in the connector to retain the fluid line to the transmission. Vehicle not included in recall number 97V084000.
Brought vehicle in once for recall on transmission cooling lines, than had to bring it back in for the same problem. Then the vehicle than broke on the highway while going at 55mph in cruise control. The vehicle's transmission just went to neutral and never went into gear again. I had to get out of the vehicle and push it of the interstate.
NHTSA campaign id number 97V084000 - our Dodge diesel pick up had the exact problems described in th afore mentiond campaign number. Beacuse it as a diesel, doge never issued a recall or took any action to correct the problem. As a result we had to have all of the transmission cooling lines and fittings replaced at a cost of $640.
A D V E R T I S E M E N T S
- Odenville, AL, USA