10.0

really awful
Crashes / Fires:
0 / 0
Injuries / Deaths:
0 / 0
Average Mileage:
0 miles

About These NHTSA Complaints:

This data is from the NHTSA — the US gov't agency tasked with vehicle safety. Complaints are spread across multiple & redundant categories, & are not organized by problem.

So how do you find out what problems are occurring? For this NHTSA complaint data, the only way is to read through the comments below. Any duplicates or errors? It's not us.

1996 Dodge Ram Conversion Van steering problems

steering problem

Find something helpful? Spread the word.
Get notified about new defects, investigations, recalls & lawsuits for the 1996 Dodge Ram Conversion Van:

Unsubscribe any time. We don't sell/share your email.

1996 Dodge Ram Conversion Van Owner Comments

problem #4

Mar 241999

Ram Conversion Van Diesel

  • Automatic transmission
  • miles

A D V E R T I S E M E N T S

When applying the brakes, vehicle has no power. Also, the power steering failed, causing consumer to put vehicle into neutral, and rev the engine. Took six months to get part after repeated calls. Front brakes wearing out prematurely because rear brakes are not self adjusting. Very unsafe when braking at higher speeds. The left rear axle seal was leaking. Water collects near the passenger door underneath the carpet.

- North Olmsted, OH, USA

problem #3

Oct 151997

(reported on)

Ram Conversion Van

  • miles
Power steering gear box drained of fluid after a minor impact of 3 mph, resulting in loss of power steering.

- Dalton, GA, USA

problem #2

Dec 211996

Ram Conversion Van

  • miles
Power steering failure.

- Fairbanks, AK, USA

problem #1

May 181996

Ram Conversion Van Diesel

  • Automatic transmission
  • miles
Consumer was driving and the steering came apart. Consumer states the upper universal joint dropped off the steering shaft, causing no steering control, the steering shaft and universal joint were not assembled properly at the factory, upper universal joint was barely stuck onto the end of the steering shaft, the universal joint was stuck onto the shaft only up to the area of the upper universal joint.

- Trenton, MO, USA

Not what you are looking for?