This could cause a wheel to fall off of the vehicle, possibly resulting in a crash.

Service Brakes, Hydraulic — Antilock/Traction Control/Electronic Limited Slip — Wheel Speed Sensor

Summary
On certain vehicles, the wheel speed sensor housing uses an O-ring seal to prevent leakage to or from the wheel bearing. If assembled improperly, the O-ring may not seal properly allowing water to enter the wheel bearing and eventually cause damage to the bearing, especially in areas where use of road salt is prevalent. If the driver continues to drive with this condition it is possible for the wheel bearing to become loose, which could cause the bearing to fail.
Actions
Dealers will inspect the rear ABS sensors and wheel bearings for damaged parts and replace them free of charge. The recall began on September 25, 2007. Owners may contact Honda at 1-800-999-1009.
Documents (17)

Click a tab for more information.

Date Announced
SEP 05, 2007
Vehicles Affected
260,000
Honda Recall #
Q56
NHTSA Campaign #
07V399000
Find something helpful? Spread the word.

Become a Fan & Spread the Word