- April 17: Ford Explorer Axle Bolt Recall Failed, Alleges Lawsuit news | 9 days ago
- March 31: Ram Aisin Transmission Snap Ring Failures Investigated investigations | 26 days ago
- March 26: Chrysler, Jeep and Ram Vehicles Recalled For Airbag Failures recalls | 31 days ago
- March 20: Ram ProMaster Vans Recalled Over Warning Lights and Chimes recalls | 37 days ago
- March 4: GM to Replace Engines in 2023 Colorado, Silverado 1500, GMC Sierra 1500 news | 53 days ago
6.0
fairly significant- Typical Repair Cost:
- $400
- Average Mileage:
- 20,250 miles
- Total Complaints:
- 4 complaints
Most Common Solutions:
- not sure (3 reports)
- replace manifolds with short tube headers (1 reports)
exhaust system problem
Helpful websites
- No one has added a helpful site for this 2013 1500 problem yet. Be the first!
A D V E R T I S E M E N T S
If you look online for hemi problems, you will read about the "hemi tick". In a nutshell, the exhaust manifolds on Gen 2 hemis suck ass and warp. This breaks the heads off the bolts, and you get to listen to a very annoying exhaust leak. The dealers have 3 options to fix under warranty - 1) replace the manifolds, 2) machine the old manifolds flat, or Fiat/Chrysler's favorite 3) replace only the bolts.
None of them are good long term fixes. After some all expense paid vacations to the dealership (warranty), the new bolts snapped off after 10,000 miles, and I drove around listening to my new diesel engine for around 50,000 miles (I wanted to make sure everyone heard this lovely machine purr, I'm petty like that).
Anyways, the only known cure to the hemi tick is to jettison those marvels of cheap metallurgy and replace them with aftermarket headers. I went with BBK as they are short tube direct replacement and I didn't have to touch the computer afterwards. Side bonus, a little extra get up and go above 3000 rpm.
- uncleswill, Rockwall, US