10.0

really awful
Crashes / Fires:
0 / 5
Injuries / Deaths:
2 / 0
Average Mileage:
5,803 miles

About These NHTSA Complaints:

This data is from the NHTSA — the US gov't agency tasked with vehicle safety. Complaints are spread across multiple & redundant categories, & are not organized by problem.

So how do you find out what problems are occurring? For this NHTSA complaint data, the only way is to read through the comments below. Any duplicates or errors? It's not us.

2019 Ram 2500 engine problems

engine problem

Find something helpful? Spread the word.
Get notified about new defects, investigations, recalls & lawsuits for the 2019 Ram 2500:

Unsubscribe any time. We don't sell/share your email.

2019 Ram 2500 Owner Comments (Page 2 of 2)

« Read the previous 20 complaints

problem #2

Jan 082020

2500 6-cyl Diesel

  • 1,500 miles

A D V E R T I S E M E N T S

2 different noises clicking noise from front of engine could be fan clutch or a pulley and ticking noise could be CP4 pump??

- Shelton, CT, USA

problem #1

Aug 202019

2500

  • 300 miles
The contact owns a 2019 Ram 2500. While driving 65 mph, the rpms increased and the engine revved. The contact released the accelerator pedal and manually shifted the gears in order to return to the correct reading. In addition, the computer system that controlled the radio and camera would glitch and hesitated to change views. Also, while driving approximately 40 mph in an intersection, the vehicle suddenly accelerated, despite depressing the brake pedal. The contact stated that the ignition and check engine warning indicators illuminated. The contact was able to pull the vehicle over to the side of the road and shifted into park; however, the vehicle continued to rev as if the accelerator pedal were depressed. When the contact turned off and restarted the vehicle, all the warning indicators illuminated and the vehicle stalled. The vehicle was towed to crown motors (located at 555 cypress ave, redding, ca 96001, 888-755-5922) where it was diagnosed that the egr valve closed and needed to be replaced. The vehicle was repaired. While driving 45 mph uphill, the vehicle stalled without warning. The contact was able to pull the vehicle over to the side of the road where it came to a rolling stop. The contact stated that the accelerator and brake pedals failed. The contact had the vehicle towed to the same dealer to be diagnosed, but no codes were found. The vehicle was not repaired. The manufacturer was made aware of the failures and provided case number: 64570388. The approximate failure mileage was 300.

- Redding, CA, USA

Not what you are looking for?