If you find CarComplaints.com is helpful ... We rely completely on word of mouth. Talk about us on Facebook, Twitter, tell your mother-in-law. Help us help more people.

1999 Plymouth Breeze

7 Recalls & Safety Reports

Recall List for the 1999 Plymouth Breeze

Official recall notices have been issued for the 1999 Plymouth Breeze by the NHTSA. The complete details of all recalls are listed below, along with what they cover and the recommended solutions. It's important to note that most recalls won't cost you anything to get fixed, so if your car is affected you should call an authorized Plymouth service shop immediately!

  1. 1999 Plymouth Breeze SUSPENSION:FRONT:CONTROL ARM:LOWER ARM NHTSA Campaign #10E059000

    • Date Announced: DECEMBER 27, 2010
    • Vehicles Affected: 22,689

    Summary: Federal-mogul is recalling certain replacement control arm assemblies, part numbers K7425, 10945, fa4510X, K7427, 10946, and fa4611X, sold for use on various passenger vehicles listed above. The ball joint on the control arm assembly can fail causing the ball stud to wear through the control arm housing resulting in noise and/or separation of the ball stud from the housing.

    Consequence: If there is a separation of the ball stud from the housing, the driver can loose steering control, possibly resulting in a vehicle crash.

    Actions: Federal-mogul will notify owners of record and replace the affected control arms free of charge. The safety recall began on January 28, 2011. Owners may contact federal-mogul at 1-877-489-6659. For detailed information & supporting documents, see the official NHTSA page concerning recall #10E059000 »

  2. 1999 Plymouth Breeze SUSPENSION:FRONT:CONTROL ARM:LOWER BALL JOINT NHTSA Campaign #09E056000

    • Date Announced: OCTOBER 09, 2009
    • Vehicles Affected: 5,787

    Summary: Qualis automotive is recalling certain aftermarket ball joints sold for use on certain passenger vehicles. The socket may have been excessively hardened which could cause it to crack near the retaining ring groove allowing the ball stud to separate under impact load. The subject ball joints were sold as four part numbers, D10945, D10946, G10945, and G10946. The affected control arms, D10945 and D10946, are stamped with the following dates on the ball joints: 134308, 135708, 100109, 102709, 104109, 105509, 107609, 108909, 110309, 113209, and 116609. The G10945 and G10946 are the same part as the D10945 and D10946 respectively. They are labeled differently depending on the aftermarket customer.

    Consequence: Separation of the ball stud from the socket of the ball joint housing would allow the control arm to collapse and the wheel to fold in causing loss of steering control, possibly resulting in a crash.

    Actions: Qualis automotive will replace the ball joints free of charge. The safety recall began on November 9, 2009. Owners may contact qualis automotive at 1-800-493-4128. For detailed information & supporting documents, see the official NHTSA page concerning recall #09E056000 »

  3. 1999 Plymouth Breeze EQUIPMENT NHTSA Campaign #09E043000

    • Date Announced: JULY 07, 2009
    • Vehicles Affected: 30,351

    Summary: Import products is recalling 30,351 fuel filters sold to and branded by the affinia group as Carquest P/N 86523, Napa P/N 3523, and Wix P/N 33523 for use as replacement equipment on the vehicles listed above. These filters may develop a leak in the hose assembly and/or connectors due to improperly adhered line connectors.

    Consequence: This condition may result in a vehicle fire.

    Actions: The affinia group will notify owners and the filters will be replaced free of charge. The safety recall began on August 1, 2009. Owners may contact Wix filter return center at 1-704-869-7411 or import products at 1-508-279-8207. For detailed information & supporting documents, see the official NHTSA page concerning recall #09E043000 »

  4. 1999 Plymouth Breeze FUEL SYSTEM, GASOLINE:DELIVERY:FUEL PUMP NHTSA Campaign #06E088000

    • Date Announced: OCTOBER 23, 2006
    • Vehicles Affected: 39,243

    Summary: Certain tigas fuel pump modules manufactured between June 1 and September 24, 2006, sold under various brand names and P/nos. These fuel pump modules are sold as aftermarket for use in certain DaimlerChrysler vehicles listed above. Silicone material used in manufacture of the flapper valve was out-of-specification, leading to excess swell of the flapper valve restricting the flow of fuel to the fuel pump module.

    Consequence: Fuel restriction could result in loss of power and/or engine stall, possibly resulting in a vehicle crash.

    Actions: Ti automotive will notify owners and replace the defective fuel pump modules free of charge. The recall began on October 6, 2006. Owners may contact ti automotive toll-free at 1-877-461-1834. For detailed information & supporting documents, see the official NHTSA page concerning recall #06E088000 »

  5. 1999 Plymouth Breeze STEERING:HYDRAULIC POWER ASSIST:HOSE, PIPING, AND CONNECTIONS NHTSA Campaign #06V001000

    • Date Announced: JANUARY 05, 2006
    • Vehicles Affected: 216,299

    Summary: On certain passenger vehicles equipped with 2.4 liter engines, the high pressure power steering hose may prematurely heat age and develop a leak.

    Consequence: Power steering fluid leakage in the presence of an ignition source may result in an underhood fire.

    Actions: Dealers will replace the high pressure power steering hose free of charge. The the recall began on April 10, 2006. Owners may contact DaimlerChrysler at 1-800-853-1403. For detailed information & supporting documents, see the official NHTSA page concerning recall #06V001000 »

  6. 1999 Plymouth Breeze POWER TRAIN:AUTOMATIC TRANSMISSION:LEVER AND LINKAGE:FLOOR SHIFT NHTSA Campaign #04V021000

    • Date Announced: JANUARY 13, 2004
    • Vehicles Affected: 2,315,768

    Summary: On certain passenger vehicles, the floor shifter ignition-park interlock may fail and allow the shifter to be moved out of the park position with the key removed. An inoperative interlock may also allow the key to be removed when the shifter has not been placed in the park position.

    Consequence: Either circumstance may result in the vehicle rolling away without warning.

    Actions: Dealers will install a new load-limiting push rod into the floor shifter lever of the affected vehicles. Owner notification began on June 14, 2004. Owners should contact DaimlerChrysler at 1-800-853-1403. For detailed information & supporting documents, see the official NHTSA page concerning recall #04V021000 »

  7. 1999 Plymouth Breeze SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:HOSES, LINES/PIPING, AND FITTINGS NHTSA Campaign #99V244000

    • Date Announced: SEPTEMBER 15, 1999
    • Vehicles Affected: 366,508

    Summary: Vehicle description: Passenger vehicles. The right rear brake tube can contact the exhaust system clamp and wear a hole in it.

    Consequence: DaimlerChrysler recall no. 843. If this happens, the tube could leak, reducing the effectiveness of one-half of the diagonally split braking system, and resulting in longer stopping distances.

    Actions: Dealers will inspect the brake tubes for visible evidence of contact with the exhaust system clamp. If the tube shows evidence of contact, it will be replaced. If no evidence of contact exists, the tube will be fastened with a clip. For detailed information & supporting documents, see the official NHTSA page concerning recall #99V244000 »

Browse Other Breeze Years