Print this page

TSB Document:

Affected Component: EQUIPMENT ADAPTIVE/MOBILITY

Summary
This Preliminary Information communication provides information to the technician about being to achieve pre-load when setting up the pinion bearing pre-loads during reassembly of the 9.5/9.76 inch rear axles. Technician will need to use pinion gear install washer part number 11609638 onto the pinion shaft between the flange and nut. Tighten the pinion nut until you achieve 10 pound inch or 1.0 newton rotating torque. After the torque has been achieved back the nut off and remove the washer. Tighten the nut back down until you achieve 15 pound inch or 1.7 newton meters for used bearings or 20 pound inch 2.25 newton meters for new bearings.

Click a tab for more information.

Date Published
OCT 29, 2015
NHTSA TSB #
10114934
Find something helpful? Spread the word.

Become a Fan & Spread the Word