3.0

definitely annoying
Crashes / Fires:
0 / 0
Injuries / Deaths:
0 / 0
Average Mileage:
46,179 miles

About These NHTSA Complaints:

This data is from the NHTSA — the US gov't agency tasked with vehicle safety. Complaints are spread across multiple & redundant categories, & are not organized by problem.

So how do you find out what problems are occurring? For this NHTSA complaint data, the only way is to read through the comments below. Any duplicates or errors? It's not us.

2009 Chrysler Town & Country wheels / hubs problems

wheels / hubs problem

Find something helpful? Spread the word.
Get notified about new defects, investigations, recalls & lawsuits for the 2009 Chrysler Town & Country:

Unsubscribe any time. We don't sell/share your email.

2009 Chrysler Town & Country Owner Comments

problem #8

Jun 062015

Town & Country

  • 79,000 miles

A D V E R T I S E M E N T S

The contact owns a 2009 Chrysler Town and country. The contact stated that all four valve stems rusted and fractured. The vehicle had to be towed to a dealer and the valve stems were replaced; however, the sensors were not replaced causing the warning light to remain illuminated. The dealer stated that the sensors should not be replaced because the stems would fracture again. The contact stated that the failure recurred. The failure mileage was 79,000. The VIN was not available.

- Newcastle, DE, USA

problem #7

Jan 132015

Town & Country

  • 90,000 miles
Tire valve stem was broken out and flattened out when I took out plastic cap for air filling because I got low tire pressure alert two month ago. I changed tire pressure sensor at my own cost over $200. But yesterday I got low tire pressure alert again, and found another valve stem was broken out again. Need to be recalled. This can cause severe situation not to control vehicle if it happens during driving.

- Rochester, MI, USA

problem #6

Jul 102012

Town & Country 6-cyl

  • 21,000 miles
The contact owns a 2009 Chrysler Town and country. The contact stated that the valve stems on the tires were all fractured. The vehicle was taken to the dealer and was repaired. The manufacturer was made aware of the failure. The failure mileage was 21,000. Mailed out customer request 11/05/2014..updated 11/06/14

- Belleville, IL, USA

problem #5

Nov 032013

Town & Country

  • 54,800 miles

A D V E R T I S E M E N T S

I was unscrewing the plastic tire valve cap and the tire valve stem broke off in my hand. Air leaked out of the tire until the tire was flat. After changing the tire to the spare took the tire to the dealer and was told it needed a $100+ TPMS sensor replacement. This is the 2nd time this has happened on this vehicle. The first was handled under warranty. These valve stems break off easily, and make the car undrivable.

- Birmingham, MI, USA

problem #4

Jun 042012

Town & Country 6-cyl

  • 46,783 miles
Tire valve stem broke off while at highway speed on an expressway causing the tire to immediately deflate! I was able to pull off on the shoulder and replaced the tire with a spare. Fortunately, the flat was on the right rear tire. If it was on the front I could have lost control and could have had a fatal accident. The tire had to be placed as well as the TPMS sensor. The mechanic informed me that this particular valve stem is made of aluminum and can fatigue do to road salt and corrosion. Surly this is a safety issue and the vehicle should be recalled. Due to the fear that this might happen again, I had the remaining sensors replaced at a significant cost to me. Please address this issue before people are killed.

- Sterling Heights, MI, USA

Search CarComplaints.com for these popular complaint phrases...

problem #3

Jan 012011

Town & Country 6-cyl

  • miles
2009 Chrysler Town & Country. Manager from the alliance for consumer protection sent correspondence on behalf of consumer in regards to blown tire and valve stem while driving 65 mph, the consumer experienced a tire blow out. The vehicle was taken to a tire shop, where the he was informed the valve stem had broke off and a rubber stem had to be installed. The sensor had to be replaced and an alignment was performed. In October 2011, while installing brakes on the vehicle, the consumer noticed another valve stem had broken off at the tip, which he also replaced. In Feb 2012, the consumer was informed that there was a hole in the valve stem again. Upon inspection of the valve stems, it was apparent, the valve stems were deteriorating from corrosion from bad metal and road elements used to treat roads in bad weather, such as salt. The consumer was convinced the valve stems were made from aluminum and the road elements were causing the valves to fail, especially in the northern part of the country.

- Monaca, PA, USA

problem #2

Oct 052011

Town & Country 6-cyl

  • 50,000 miles
Sometime in the beginning of October 2011 while checking/ adjusting the air pressure in my tires the rh front valve stem snapped off just below where the valve core threads in causing a complete loss of pressure. This seemed like a fluke problem, so the stem was replaced at my own cost. Today, 12/1/2011, while checking/ adjusting the air pressure again the rh rear valve stem snapped off just like the previous one did approx. 2 months ago. Some fluke occurrence? not twice. Once again the part was replaced at my own cost/ time so we weren't down a vehicle. In my opinion it appears that the metal valve stems for the TPMS are made of a faulty grade metal, and or the valve cores were over torqued, causing a fracture/ stress crack in the stem. After doing some research on the internet this seems to be quite a problem with at least several hundred Dodge/ Chrysler owners. In a way this makes me feel better being it's not just me that this is happening to, but it's definitely not an isolated incident. Now I still have two tires that have not had this problem yet, but when time allows I will be replacing all the valve stems with rubber ones and just dealing with the TPMS idiot light being on in the dash. So much for new/ easier to use technology! this wont cause an issue with me, living in Michigan because we don't have vehicle inspections, but there are several states that will fail an inspection if the TPMS light is on. In closing, luckily these valve stems failed while servicing the vehicle, and not driving down the road at 55+ mph, otherwise the results might not have been the same. I've worked in quality control for the automotive manufacturing industry for 20+ years producing and inspecting tight tolerance/ safety related parts, and feel that this really needs to be looked into further. It is a definite safety concern.

- Hillsdale, MI, USA

problem #1

Aug 032011

Town & Country

  • 27,851 miles
The contact owns a 2009 Chrysler Town and country. The contact stated the tire stem sensor failed on the rear drivers side causing the tire to deflate. Being put in the tire the stem popped out causing the tire to go flat. The tire stem manufacturer was siemens model#787ao/833707093. The tire stem sensor was replaced for $100 at the owners expense. The contact was expecting a follow up phone call from the manufacturer. The failure mileage was 27,851.

- South Holland, IL, USA

Not what you are looking for?