3.8

definitely annoying
Crashes / Fires:
0 / 0
Injuries / Deaths:
0 / 0
Average Mileage:
32,092 miles

About These NHTSA Complaints:

This data is from the NHTSA — the US gov't agency tasked with vehicle safety. Complaints are spread across multiple & redundant categories, & are not organized by problem.

So how do you find out what problems are occurring? For this NHTSA complaint data, the only way is to read through the comments below. Any duplicates or errors? It's not us.

1999 Dodge Ram Van 2500 steering problems

steering problem

Find something helpful? Spread the word.
Get notified about new defects, investigations, recalls & lawsuits for the 1999 Dodge Ram Van 2500:

Unsubscribe any time. We don't sell/share your email.

1999 Dodge Ram Van 2500 Owner Comments

problem #2

Mar 032003

Ram Van 2500 4WD

  • Manual transmission
  • miles

A D V E R T I S E M E N T S

Replacement of intake gasket/ catalytic converter has gone bad/ tie rod went bad. Mr the consumer experienced some belt squealing in the engine compartment. The belt was replaced under warranty. The consumer took the vehicle back to the dealer because of an engine noise. The tires were discovered to be worn.

- Watertown, WI, USA

problem #1

Jul 122004

Ram Van 2500 8-cyl

  • Automatic transmission
  • 64,185 miles
The following is regarding a 1999 Dodge Ram 2500 van and failure of tie rods. At approximately 30,000 miles both outer tie rod ends were replaced by a dealer for torn rubber boots. At approximately 64,000 miles another tie rod failure occurred. This time it was the adjusting sleeve. The sleeve had become loose on the tie rod end and had developed sufficient movement to wear the threads down to the point where total failure (separation) of the tie rod was imminent. This occurred approximately 3,000 miles after a state inspection and with very little warning. Because the vehicle has power steering (which has a very dead feeling), the tie rod had to be very near failure before its effect could be felt in the steering. Obviously I feel this is a serious defect because tie rod separation while moving is going to result in a loss of control (go right into the ditch or worse go left into oncoming traffic). While my degree is in electrical engineering, I feel I have had enough mechanical experience and experience working on cars to offer the following comment. I think Dodge's design with a sleeve that is split its entire length and depends solely on the clamps for integrity is very poor. For example, Mitsubishi uses a solid adjusting section with two jam nuts. Toyota again uses a solid section that is split only at the ends where the clamps are used to prevent rotation. Both of the latter two designs allow for a more positive engagement of the threads.

- Slippery Rock, PA, USA

Not what you are looking for?