really awful
Crashes / Fires:
0 / 0
Injuries / Deaths:
0 / 0
Average Mileage:
3 miles

About These NHTSA Complaints:

This data is from the NHTSA — the US gov't agency tasked with vehicle safety. Complaints are spread across multiple & redundant categories, & are not organized by problem.

So how do you find out what problems are occurring? For this NHTSA complaint data, the only way is to read through the comments below. Any duplicates or errors? It's not us.

2010 Ford Transit Connect lights problems

lights problem

Find something helpful? Spread the word.
Get notified about new defects, investigations, recalls & lawsuits for the 2010 Ford Transit Connect:

Unsubscribe any time. We don't sell/share your email.

2010 Ford Transit Connect Owner Comments

problem #3

Apr 162010

Transit Connect

  • 0 miles


Lane change turn signal. Ford has vehicles with the lance change signal, where when tapping the turn signal handle, the signal flashes 3 times. In Wisconsin and I assume all states, the law states that one must indicate in advance the intent of lane change or turn and continue signal until completed. Three flashes does not provide adequate warning. Should be 6-8 flashes. Contacted Ford customer service and dealer. No way to adjust the number of flashes, and customer service says as long as working according to specs, that is all that matters.

- Port Washignton, WI, USA

problem #2

Jun 202010

Transit Connect

  • 10 miles
Led use is missing the appropriate level of rigger for correct human factors! the operating frequencies of pwm (pulse width modulation) led's (light emitting diode) is to low for some viewers! this is a very real condition known as flicker Fusion or critical Fusion frequency and does not have the same effect on all viewers. The lamps look as if they are all over the roadway and completely out of control! it is just about impossible to drive at night due to this!!!! all manufactures using led's or other fast response lamps need to consider human factors, the operating frequency is critical and needs to be over 3000 hertz (cycles per second). This lack of control has put probable 10% of the drivers and Pilot are at risk! a recall is needed to fix this travesty that is out of control. It started with Cadillac's srx around 2000, now in 2010+ Ford, 2010+ Mercedes and Volkswagen have gone overboard and just about all the vehicles they build are operating at this dangerous and very deadly operating frequency. The operating frequency needs to be >2500 hertz! the use of pwm is not the problem it's the operating frequency! all manufactures that use pwm need to consider human factors!

- Wildomar, CA, USA

problem #1

Aug 212010

Transit Connect

  • miles
Flicker effect! this needs action now; the operating frequency on some vehicles did not consider human factors. The operating frequency needs to be above 3000 hertz, this needs a recall to correct this on all vehicles that do not conform. The choice of flicker Fusion threshold operating frequency is going to get someone killed or maybe it already has! what is needed: Recall all delenators, road side signs, signal lights and vehicles that use pwm "pulse width modulation". and are operating below 3000 hertz!! set a standard for this!!!

- Wildomar, CA, USA

Not what you are looking for?