Print this page

TSB Document:

Affected Component: ENGINE AND ENGINE COOLING

Summary
TT: The current engine active test ?Control the Injection Mode? is not operating as desired when controlling the direct injectors manually on 2GR-FKS engines. When direct injection is started and then stopped using the active test, current ECU logic does not turn off the direct injectors and can cause DTCs P017200, P017500 and P0160300. To avoid this condition, technicians should raise engine RPM when changing back and forth between the Direct Injection and Port Injection active tests. Use the recommended procedure below to avoid this concern while testing injection mode of FKS equipped vehicles. NOTE: If the active test is used multiple times without using this procedure to raise engine RPM, it may be necessary to reset learning values for fuel trim and Air to Fuel ratio before returning vehicle to customer.

Click a tab for more information.

Date Published
JAN 16, 2019
NHTSA TSB #
10153246
Find something helpful? Spread the word.

Become a Fan & Spread the Word