- April 17: GM Shift to Park Recall Needed, Alleges Class Action Lawsuit news | 5 days ago
- March 10: GM Trucks Suffer Automatic Emergency Braking Incidents recalls | 43 days ago
- March 4: GM to Replace Engines in 2023 Colorado, Silverado 1500, GMC Sierra 1500 news | 49 days ago
- February 22: Chevy Silverado Crushed Roof Lawsuit Moves Forward news | 60 days ago
- February 12: Chevrolet Cruze Class Action Lawsuit: No Settlement news | 70 days ago
Chevrolet TSB #PIP5097A
2014 Chevrolet Camaro
TSB Document:
Affected Component: POWER TRAIN:AXLE ASSEMBLY
- Summary
- This Preliminary Information communication provides the technician with the following steps to correct a moan noise from the rear axle during cold turning maneuvers. This noise might start to be noticed as the vehicle accumulates over 3000 miles. The technician is to perform the following steps. 1. With original lube in axle, conduct Freeway Speeds for 10 miles to warm up lube. 2. Immediately drain original lube and refill with fresh lube. 3. In parking lot lock steering to the right, and then execute 5 Full Circles at (5-10 mph). 4. . In parking lot lock steering to the left, and then execute 5 Full Circles at (5-10 mph). 5. Perform 4 Figure 8?s at (5-10 mph). 6. Freeway Speeds for 20 miles until operating temperature is achieved. 7. In parking lot lock steering to the right, and then execute 5 Full Circles at (5-10 mph). 8. In parking lot lock steering to the left, and then execute 5 Full Circles at (5-10 mph). 9. Perform 4 Figure 8?s at (5-10 mph). 10. Immediately drain current lube in axle and refill with fresh lube. 11. Perform Steps 3 thru 9 again. 12. Immediately drain current lube in axle and refill with fresh lube. Proceed with steps 2 through 9 two times, for a total of 3 drain and fill procedures. This should only be done for a moan noise from the rear axle during cold start turning maneuvers. During regular maintenance the fluid only needs to be changed one time.
Click a tab for more information.