- February 25: MyFord Touch Class-Action Lawsuit Awaits Trial news | 0 days ago
- February 14: Brake Fluid Leaks Cause Ford Escape and Lincoln MKC Recall recalls | 11 days ago
- February 13: 2006 Ford Ranger Owners Warned to Park the Trucks recalls | 12 days ago
- February 1: Exploding Sunroof in Ford Escape Causes Lawsuit news | 24 days ago
- January 29: Ford Focus Suspension Lawsuit is Over news | 27 days ago
2002 Ford Windstar
6 Defect Investigations from the NHTSA
NHTSA Defect Investigations for the 2002 Ford Windstar
The Office of Defects Investigations (ODI) is an office within the NHTSA which investigates serious safety problems in the design, construction or performance of vehicles. The NHTSA is authorized to order manufacturers to recall and repair vehicles, if the ODI finds a safety issue. NHTSA investigations for the 2002 Ford Windstar, both ongoing and closed, are listed below:
ENGINE COMPARTMENT FIRES NHTSA Preliminary Evaluation #PE08035
Component(s): Electrical System
Vehicle Speed Control
Summary: ODI has received 134 consumer complaints, 285 manufacturer complaints, and 137 manufacturer warranty claims alleging incidents of engine compartment fire in model year (MY) 1995 thru 2003 Ford Windstar vehicles.two of the ODI complaints allege the fires caused structural damage to the complainant's home.of the 134 ODI complaints, 36 allege the fire occurred while the vehicle was parked, 72 allege the fire occurred while the vehicle was running and 26 of the complaints do not specify if the vehicle was running or not.further review of the ODI complaints shows that 72 allege that the speed control deactivation switch (scds) caused the fire and 10 allege that the scds leaked brake fluid on to the ABS module resulting in the fire.there were 52 that did not identify a cause or that identified miscellaneous other causes.ODI has also received 89 complaints ( not counted in this resume) alleging that the scds developed a brake fluid leak.thirteen of these complaints say that the leak at the scds resulted in braked fluid reaching the ABS module.this PE has been upgraded to an engineering analysis (ea) to further evaluate the cause of the fires and assess the scope, frequency, and safety consequences of the alleged defect.
NHTSA: For detailed information & supporting documents, see the official NHTSA page concerning investigation #PE08035 »
ENGINE COMPARTMENT FIRES NHTSA Engineering Analysis #EA08021
Component(s): Electrical System
Service Brakes, Hydraulic
Service Brakes, Hydraulic:Antilock
Service Brakes, Hydraulic:Antilock:Control Unit/Module
Vehicle Speed Control
Vehicle Speed Control:Cruise Control
Summary: EA08-021 is closed with Ford's actions in recall 09V-399 recalling approximately 4.5 million vehicles equipped with Texas instruments speed control deactivation switches (scds).with this recall Ford has now recalled all of the approximate 16 million Ford model vehicles that were manufactured from MY 1992 through 2003 with a Texas instruments scds.NHTSA will continue to monitor the recalled vehicles to ensure remedies installed by Ford tomitigate the potential for scds related fires are effective.the Agency reserves the right to take further action if warranted by the circumstances.see attached closing report for further details.
NHTSA: For detailed information & supporting documents, see the official NHTSA page concerning investigation #EA08021 »
POWER SLIDING DOOR OPENING NHTSA Preliminary Evaluation #PE04022
Structure:Body:Door:Hinge And Attachments
Summary: The subject vehicles are equipped with single or dual power sliding doors (PSD).approximately 111,000 vehicles have dual power sliding doors.the PSD is opened by any of 5 methods, the inside or outside manual door handle, the key fob, the overhead console switch and the B-pillar switch.the door may be opened only under these conditions: Ignition key is in off/accessories/on/start position, gear selector in park, vehicle speed less than 6 mph, and door unlocked.the PSD latch is located at the rear of the door and has a secondary and primary latch position.full and proper closure engages both the secondary and primary latch.with the ignition in the on position, as the gear selector is moved out of park the door automatically locks and that action mechanically isolates the latch, secondary and primary, from all latch release connections.in addition to the reports alleging door opening while driving, Ford has received approximately 5,700 reports that allege the door does not close properly or "pops" open with no mention of "while driving."Ford's investigation into these report included owner interviews, vehicle by-backs and testing of consumer vehicles.it found that allegations of door opening while driving were "in fact reports of doors not being properly closed initially and subsequently opening to the secondary latch position as a result of vehicle vibrations or driving maneuvers."Ford's testing of consumer vehicles did not result in any recurrence of "PSD opening while being driven."ODI interviews with owners affirmed the allegations of PSD opening while driving; however owners indicated the event is not a regular occurrence (I.e.,it occurred only once or has not occurred recently) and that the unintended PSD opening may not be able to be duplicated.in contrast, the improper closing of the PSD (latching on the secondary but not the primary latch) can be duplicated, and ODI verified this during an inspection of a consumer vehicle.in this condition (secondary but no primary latch), when the vehicle's gear selector is moved out of park position, a warning chime sounds and warning message appears on the instrument panel.most reports and warranty claims were filed in the early service-life of the vehicle and peaked around the 18-month in-service time period.ODI and mfr complaint trends are declining over the last 8 quarters.there is no alleged injury associated with occupant falling out while the vehicle is in motion.no failure mode causing full door opening while vehicle is in motion has been verified (reproduced by ODI or by trained service technicians at dealerships) during this investigation.a safety-related defect has not been identified at this time and further use of Agency resources does not appear to be warranted.accordingly, this investigation is closed.the closing of this investigation does not constitute a finding by NHTSA that a safety-related defect does not exist.the Agency will monitor this issue and reserves the right to take further action if warranted by the circumstances.
NHTSA: For detailed information & supporting documents, see the official NHTSA page concerning investigation #PE04022 »
Front Subframe Corrosion Failures NHTSA Engineering Analysis #EA10007
Component(s): Structure:Frame And Members
Summary: In a January 26, 2011 Defect Information Report, Ford Motor Company (Ford) notified the National Highway Traffic Safety Administration (NHTSA) that it will conduct a safety recall to address corrosion related fractures in the front lower control arm rear attaching brackets and body mount attachments at the rear of the front subframe in approximately 425,288 model year (MY) 1999 through 2003 Ford Windstar vehicles manufactured from April 1998 to July 2003 and either sold or currently registered in the following high corrosion (Salt-Belt) states:Connecticut, Delaware, District of Columbia, Illinois, Indiana, Iowa, Kentucky, Maine, Maryland, Massachusetts, Michigan, Minnesota, Missouri, New Hampshire, New Jersey, New York, Ohio, Pennsylvania, Rhode Island, Utah, Vermont, West Virginia and Wisconsin (NHTSA Recall No. 11V-030, Ford Recall No. 11S16).According to Ford, separation of a front lower control arm rear attaching bracket may result in a lower control arm separation and separations of both front subframe rear body mounts may result in separation of the steering intermediate shaft.Either condition could result in diminished vehicle directional control, increasing the risk of a crash.Dealers will inspect the lower control arm rear attachment flanges and the rear body mount sections of the subframe on the right (passenger) and left (driver) sides of the vehicle.Owners of vehicles that pass the inspection will be notified when to return for installation of reinforcement brackets to extend the durability of the front subframe assembly in affected areas in the presence of corrosion.Owners of vehicles that do not pass inspection, but can be repaired, will be offered transportation until parts become available.Repurchase offers will be extended to owners of vehicles that cannot be repaired with the reinforcement brackets.This investigation is closed.
NHTSA: For detailed information & supporting documents, see the official NHTSA page concerning investigation #EA10007 »
Front Subframe Corrosion Failures NHTSA Preliminary Evaluation #PE10026
Component(s): Structure:Frame And Members
Summary: The Office of Defects Investigation (ODI) has identified 346 complaints to ODI and Ford alleging fracture, cracking and or excessive corrosion of the front subframes in model year (MY) 1999 through 2003 Ford Windstar vehicles.Approximately 97 percent of these complaints (334) involve vehicles that have been operated in Salt Belt states, which make up approximately 60 percent of the subject vehicle sales in the United States.The front subframe, sometimes referred to as the engine cradle, is a structural component of the Windstar vehicles that carries the engine, transaxle, steering rack and certain front suspension components (e.g., lower control arm).For complaints with sufficient information to identify the location of the failure, most describe problems with the rear mounting bracket for the front passenger-side lower control arm with some related to the rear body mount attachment located in the same general area of the subframe (right-rear section near the front passenger wheel).The remainder of the reports allege fracture of the front subframe at other or, most often, unspecified locations.Almost all of the complaints that specified the side of the vehicle indicated that the problem occurred on the right/passenger side (106), with only a few indicating the left/driver side (2) or both sides (3) were affected.Ford and several complainants attributed the right-side failures to the routing of the air-conditioning lines above the front subframe on that side of the vehicle, further noting that condensation has been observed dripping onto the front subframe in the area of the affected components (the A/C drain tube is also located on the right side, near the front subframe).ODI has identified 93 complaints related to lower control arm attachments, including 80 that appear to involve complete separations.All but one of these involved vehicles from Salt Belt states.All three crash incidents appear to be related to lower control arm separations, including one road departure into a road-side sign resulting in a totalled vehicle and a lane departure into another vehicle.Almost half of the ODI complaints related to control arm separation occurred at speeds greater than 20 mph and about a quarter occurred at highway speeds.Three-quarters of these complaints allege experiencing difficulty controlling the vehicle and about 40 percent appear to have resulted in departures from the intended lane of travel.Testing by both Ford and NHTSA have demonstrated that lower control arm separation from the rear attachment bracket results in significant toe out of the affected wheel, which affects the driver's ability to control vehicle direction.According to Ford, moderate braking improved vehicle controllability by reducing the amount of toe out, possibly explaining incidents that did not allege a loss of control.ODI's analysis of complaints related to the rear body mount identified 41 complaints (ODI only).These complaints generally report experiencing progressively worsening noise concerns when turning, accelerating or braking.Although, some of the complaints that appeared to involve a complete separation of the body mount alleged difficulty steering, the effects on vehicle control from this failure mode do not appear to be as great as those resulting from control arm separation.However, ODI is seeking more information regarding two complaints which alleged that body mount failure resulted in disconnection of the steering wheel from the steering rack (one occurred during vehicle service).This investigation has been upgraded to an Engineering Analysis (EA10-007) for subject vehicles sold or currently registered in Salt Belt states to further assess the scope, frequency and safety consequences of the alleged defect in these vehicles.ODI will continue to gather information about vehicles outside the Salt Belt as well.
NHTSA: For detailed information & supporting documents, see the official NHTSA page concerning investigation #PE10026 »
Rear Axle Cracking NHTSA Preliminary Evaluation #PE10016
Summary: In a letter dated August 26, 2010, Ford Motor Company (Ford) submitted a Defect Information Report notifying NHTSA that it will conduct a safety recall (NHTSA Recall No. 10V-385) to address a rear axle defect in model year (MY) 1998 through 2003 Ford Windstar vehicles built at the Oakville assembly plant from September 1, 1997 through February 28, 2003 and either sold or currently registered in high corrosion (Salt-Belt) states where the use of salt and other corrosive chemicals may be used to treat snow/ice covered roads.The following states are included in Ford's recall:Connecticut, Delaware, District of Columbia, Illinois, Indiana, Iowa, Kentucky, Maine, Maryland, Massachusetts, Michigan, Minnesota, Missouri, New Hampshire, New Jersey, New York, Ohio, Pennsylvania, Rhode Island, Vermont, West Virginia and Wisconsin. The subject vehicles utilize a Stamped/Formed axle assembly manufactured by Benteler automotive Corporation of Galesburg, MI.According to Ford, after many years of vehicle service in the Salt-Belt states, corrosion can weaken the rear axle, making it susceptible to torsional stress.There is a risk that the combined effects of corrosion and stress can lead to cracks which, if undetected, can propagate and result in a complete fracture of the axle.A completely fractured axle can affect vehicle handling and increase the risk of a crash.To correct the safety defect, Ford will initially inspect all of the subject vehicles brought into Ford/Lincoln-Mercury dealerships for possible cracked axles.Owners of vehicles without cracked axles will be notified when to return for the installation of reinforcement brackets to extend the axle durability in the presence of corrosion.Owners who have vehicles with cracked axles will either be offered a repair or alternative transportation until parts become available. On May 13, 2010, the Office of Defects Investigation (ODI) opened PE10-016 to investigate complaints of rear axle cracking in MY 1999 through 2003 Ford Windstar minivans.Combining ODI and Ford complaint data, ODI is aware of a total 891 complaints alleging rear axle cracking in the subject vehicles.Over a third of the complaints (334) allege that the cracking progressed to a complete fracture of the rear axle, including 8 allegations of crashes resulting in 3 injuries. Approximately 57 percent of the subject vehicles (524,661) were sold in Salt-Belt states covered by Ford's recall and Ford estimates that approximately 463,000 of these remain in service.Ninety-six percent of the complaints (858) and all of the complaints alleging complete fracture were from the recall region.The action taken by Ford is sufficient to resolve the issues raised by this investigation.Accordingly, this investigation is closed.
NHTSA: For detailed information & supporting documents, see the official NHTSA page concerning investigation #PE10016 »