NHTSA Defect Investigations for the 2007 Mercury Grand Marquis

The Office of Defects Investigations (ODI) is an office within the NHTSA which investigates serious safety problems in the design, construction or performance of vehicles. The NHTSA is authorized to order manufacturers to recall and repair vehicles, if the ODI finds a safety issue. NHTSA investigations for the 2007 Mercury Grand Marquis, both ongoing and closed, are listed below:

  1. Steering Column Shaft Obstruction NHTSA Preliminary Evaluation #PE14021

    • Status:
      CLOSED
    • Date Opened: July 07, 2014
    • Date Closed: November 21, 2014
    • Recall: no recall issued

    Component(s): Engine And Engine Cooling:Exhaust System
    Steering

    Summary: On July 7, 2014 the Office of Defects Investigation (ODI) opened a preliminary evaluation based on five complaints (VOQs) alleging incidents ofinterference between dislodged exhaust manifold heat shields and the lower steering shaft/knuckle, including one alleging the interference resulted in a crash on a highway entrance ramp. Since opening this investigation, ODI has received four additional owner complaints.One indicated that the shield was removed before binding could occur.The other three occurred at low speed and produced some momentary steering binding that was overcome by the driver when additional steering effort was applied.Once the shield was repaired or removed, the steering returned to normal.The single incident ODI identified as a possible crash (VOQ No. 10578715) related to this condition could not be verified and the description of the crash in the complaint was not supported by the police accident report.No additional crash allegations have been identified related to the alleged defect condition.Information provided by Ford in its September 10, 2014 response to ODI's information request letter identified 10 additional incidents resulting in a low rate of 1.6 incidents per 100,000 vehicles sold in vehicles ranging from 7 to 11 years in service.Six of these incidents were reported by a single source, a state police fleet that corrected the problems in March 2011 and has not reported any additional failures since.Ford also reported 5 warranty claims, but these incidents occurred at very low mileages and appeared to be caused by loose or missing heat shield attachment hardware rather than the corrosion condition that was the cause of the more recent incidents and the focus of this investigation.This investigation is closed. The closing of this investigation does not constitute a finding by NHTSA that a safety-related defect does not exist. The Agency will continue to monitor complaints and other information relating to the alleged defect in the subject vehicles and take further action in the future if warranted.The following VOQs are associated with this investigation:10643753, 10615584, 10611362, 10610451, 10578715, 10479681, 10471833, 10317493.

    NHTSA: For detailed information & supporting documents, see the official NHTSA page concerning investigation #PE14021 »

  2. TIRE VALVE CRACKING NHTSA Preliminary Evaluation #PE08060

    • Status:
      CLOSED
    • Date Opened: October 14, 2008
    • Date Closed: April 09, 2009
    • Recall: no recall issued

    Component(s): Tires:Valve

    Summary: On October 14, 2008, ODI opened PE08-060 to investigate allegations of cracked and leaking snap-in tire valves in model year (MY) 2007 vehicles manufactured by Ford Motor Company.the valves were supplied to Ford by topseal auto-parts, a subsidiary of the shanghai baolong automotive corporation in china.valves made by topseal for aftermarket sale were the subject of two recent safety recalls by tech international (08T-018) and dill air controls (08T-028), the latter of which was investigated by ODI in PE08-036 and EA08-022.the defect conditions addressed by the aftermarket tire valve recalls both involved inadequate resistance to ozone cracking due to issues with the supply of anti-ozonant chemicals to topseal for a period from July to mid-November 2006.the aftermarket valves were compounded with a blend of epdm and natural rubber, using a relatively low percentage of epdm (epdm provides inherent resistance to ozone cracking).hence, the need for anti-ozonant chemicals and the problems with cracking when those chemicals were missing or out of specification in some lots of valves.both recall campaigns involved inspection programs to identify and replace valves with visible surface cracking.although the topseal valves supplied to Ford also appear to have been affected by the anti-ozonant supply issues in mid to late-2006, Ford indicated that its valves were made at a different topseal production line and were compounded with a higher percentage of epdm rubber to meet more stringent specifications from Ford.ODI's analysis of complaint and warranty data provided by Ford showed that problems with cracked tire valves were significantly higher for MY 2007 vehicles produced from December 2006 through March 2007.Ford responded by implementing changes in its material specifications for snap-in rubber tire valves and also increasing the quality and acceptance standards for valves imported for use in its vehicles.while the complaint and warranty claim rates are elevated for subject vehicles produced from December 2006 through March 2007, the rates of leaking valves are well below one percent of production for each of the peak months for all of the affected models.a substantial majority of the subject vehicles are equipped with tire pressure monitoring systems (TPMS) which warn the driver when any tire pressures drops below 25 percent of recommended inflation pressure. As outlined in a letter to ODI dated April 6, 2009, Ford has agreed to send letters to owners of certain MY 2007 and 2008 Ford, Lincoln and Mercury vehicles to provide information about the cracking concern. Letters will be sent to owners of vehicles built from November 2006 through May 2007.owners can opt for a free dealer inspection.valves exhibiting surface cracks or air leakage related to ozone attack will be replaced by Ford under its normal warranty terms.Ford expects to send the letter by approximately mid-May 2009. Based on the use of TPMS in the majority of subject vehicles and the relatively low rates of repairs associated with leaking valves and resultant tire damage, ODI believes that the actions Ford has agreed to take will provide effective and expeditious resolution for vehicles that were built during the period when valves with inadequate resistance to ozone cracking were most likely to have been used in vehicle production.further investigation of this matter would not be an efficient allocation of Agency resources.accordingly, this investigation is closed.the closing of this investigation does not constitute a finding by NHTSA that a safety-related defect does not exist.the Agency will continue to monitor complaints and other information relating to the alleged defect in the subject vehicles and take further action in the future if warranted.

    NHTSA: For detailed information & supporting documents, see the official NHTSA page concerning investigation #PE08060 »

Browse Other Grand Marquis Years