- August 19: GM Recalls 3000 Vehicles For Damaged Block Heater Cords
- August 15: GM Recalls 124,000 Vehicles With Seats That Could Fly Loose
- August 8: GM Recalls 269,000 Vehicles, 66th Recall of 2014
- August 5: GM Re-Recalls 184,000 Vehicles Over Door Fire Risk
- June 16: Millions More GM Cars Have Defective Ignition Switches
2000 Buick LeSabre
5 Recalls & Safety Reports
Recall List for the 2000 Buick LeSabre
Official recall notices have been issued for the 2000 Buick LeSabre by the NHTSA. The complete details of all recalls are listed below, along with what they cover and the recommended solutions. It's important to note that most recalls won't cost you anything to get fixed, so if your car is affected you should call an authorized Buick service shop immediately!
2000 Buick LeSabre FUEL SYSTEM, GASOLINE:DELIVERY NHTSA Campaign #04V090000
Summary: On certain passenger vehicles equipped with 3800 V6 (L36) engines and certain delphi fuel pressure regulators, the regulators have a much higher than usual rate of fuel leaks. A leak can allow fuel to enter the intake manifold through a vacuum line. If the engine does not start when cranked, the fuel from the leaking regulator and a mistimed spark can cause a backfire.
Consequence: The backfire can rupture the intake manifold. The rupture of the intake manifold can displace a fuel line, pulling an injector out of place, and causing a fuel leak and possible fire.
Actions: Dealers will install new fuel pressure regulators with improved diaphragms. The recall will be conducted in phased mailings. Phase 1 began on June 30, 2004, and phase 2 began on September 30, 2004. Owners should contact Buick at 1-866-608-8080, Oldsmobile at 1-800-630-6537, or Pontiac at 1-800-620-7668. For detailed information & supporting documents, see the official NHTSA page concerning recall #04V090000 »
2000 Buick LeSabre SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS NHTSA Campaign #00V114000
Summary: Vehicle description: Passenger vehicles. Some of these vehicles have internal fluid leaks in the brake hydraulic control unit.
Consequence: When the rear brake proportioning, antilock brake, traction control, or stability control feature is activated in some driving situations, the feature may not perform as designed.
Actions: Dealers will inspect the ABS hydraulic modulator unit and if necessary, replace the hydraulic modulator. For detailed information & supporting documents, see the official NHTSA page concerning recall #00V114000 »
2000 Buick LeSabre EXTERIOR LIGHTING:HEADLIGHTS NHTSA Campaign #99V355000
Summary: Vehicle description: Passenger vehicles. These vehicles do not conform to the requirements of FMVSS no. 108, "lamps, reflective devices, and associated equipment." The head lamp adjustment device horizontal adjuster may not move the head lamp reflector when the shaft is rotated in a normal manner during aiming.
Consequence: Driver visibility may be impaired increasing the risk of a crash.
Actions: An insert containing instructions for optically aiming the headlamps will be provided to owners for the owner's manual. Owners should follow the procedure in the insert for headlamp aim adjustment, rather than using the horizontal vhad indicator. For detailed information & supporting documents, see the official NHTSA page concerning recall #99V355000 »
2000 Buick LeSabre STEERING:LINKAGES:TIE ROD ASSEMBLY NHTSA Campaign #99V301000
Summary: Vehicle description: Passenger vehicles. The inner tie rod nuts are loose and can result in separation of a tie rod.
Consequence: Separation of a tie rod can cause unexpected steering input increasing the risk of a crash.
Actions: Dealers will check and adjust the vehicle toe-in and tighten the inner tie rod nuts to the specified torque. For detailed information & supporting documents, see the official NHTSA page concerning recall #99V301000 »
2000 Buick LeSabre SERVICE BRAKES, HYDRAULIC:POWER ASSIST:VACUUM NHTSA Campaign #99V238000
Summary: Vehicle description: Passenger vehicles. The brake booster to pedal assembly attachment nuts may be loose.
Consequence: If these nuts are loose, the brake pedal may be low, the assembly may be loose, the brakes may not release, and if the nuts back completely off, braking may be lost. Also fume and water intrusion to the passenger compartment can occur.
Actions: Dealers will replace any missing brake booster to brake pedal assembly nuts and tighten all four (4) nuts to specified torque. For detailed information & supporting documents, see the official NHTSA page concerning recall #99V238000 »
Browse Other LeSabre Years
- 2005 Buick LeSabre
- 2004 Buick LeSabre
- 2003 Buick LeSabre
- 2002 Buick LeSabre
- 2001 Buick LeSabre
- 1999 Buick LeSabre
- 1998 Buick LeSabre
- 1997 Buick LeSabre
- 1996 Buick LeSabre
- 1995 Buick LeSabre
- 1994 Buick LeSabre
- 1993 Buick LeSabre
- 1992 Buick LeSabre
- 1991 Buick LeSabre