This data is from the NHTSA — the US gov't agency tasked with vehicle safety. Complaints are spread across multiple & redundant categories, & are not organized by problem.
So how do you find out what problems are occurring? For this NHTSA complaint data, the only way is to read through the comments below. Any duplicates or errors? It's not us.
Brakes seem to sputter/skip when applying when traveling above 40 mph. I had an inspection done with Brake Masters. They inspected brake pads, rotors and performed a road test. They stated Brakes pads and rotors were still good about another year left. They did say brakes sputtered at about 40 mph and over. They thought it could be issue with brake vacuum system Thanks
the brakes have a hard pedal with no brakes at low speed. In reverse have to apply lots of pressure to brake pedal, and this does not always work. I read there is a recall. I want to get repaired before an accident occurs. This is on going, not just the date below.
I believe my 2014 silverado has a recall for the vacuum brake pump. I just purchased the truck a month ago And I noticed when I take off in drive or reverse and hit the brake pedal it doesn-??t want to move and becomes stiff. It has almost caused me to have 2 accidents now. After doing research and looking things up I have come to know there as a recall on these trucks for the vacuum brake pump and I don-??t think this truck has ever been fixed for it. I would like to get this fixed before it causes an accident.
When stopping at slow speeds in stop and go traffic my abs would kick on and the power breaks would not work and I would need to press the break pedal very hard to stop. Only seems to happen in stop and go traffic at slow speeds but it's super scarey.
Truck has rough breaking at low speeds. It-??s due to the break pump recall on this make, year and model. The break pump also makes a clicking sound when engine is running. Common in these trucks.
- Grass Valley , CA, USA
Search CarComplaints.com for these popular complaint phrases...
My vehicle lost the ability to apply brakes or slow down, the vehicle had a rock hard peddle at low speed. There was no illuminated light on the dashboard no warning! I barely avoided a collision and scraped my truck driving off the road to try and stop it. The issue is worst at lower RPM!
Multiple GM vehicles have an error with the traction control system that they cannot diagnose and continuously dismiss to cover their mistakes. Many makes and models report warnings to Service Stabilitrak and Service Breaks along with numerous other warnings. After the warning, drivers are experiencing power failure, locking steering wheels, wrecks, exponential costs for investigations, and temporary fixes. GM will not release any information on investigations into this matter. GM Technicians can not adequately diagnose the issue and will say there is a grounding problem, Traction Control module needs to be reset, replace the battery, and many other bogus repairs to temporarily fix the problem. How many people will have to experience these mechanical errors that can cause serious wrecks or fatalities before NHTSA or GM will investigate? All GM owners should be absolutely disappointed and disgusted with the response from the safety measures put in place to "protect us."
The contact owns a 2014 Chevrolet Silverado 1500. The contact stated while entering the vehicle, he noticed that the passenger-??s side window failed to work as designed. Additionally, there was water leaking into the vehicle whenever it rained. The contact also stated that the brakes would not engage when the brake pedal was depressed. There was no warning light illuminated. The vehicle was taken to an independent mechanic where it was diagnosed with the window-??s wiring harness needing to be replaced. The vehicle was repaired. The contact was relating the failure to an unknown recall. The manufacturer had not been informed of the failure. The failure mileage was approximately 67,331.
Towing 16ft stock trailer with 2 calves- Turning Left onto another 2 lane road which was downhill, Engine shut off during turn, power steering went out, had truck brakes pressed to floor, trailer brakes didn't react. Took everything I had to turn the steering wheel to keep from going off embankment on both sides of road. Finally got stopped when road flattened out. Thank goodness no oncoming vehicle!!! Message on dash to roll up drivers side window. Truck restarted! Truck only has 60100 miles. What is going on with this truck" I could have injured myself or someone else" Thank you in advance for allowing me to voice what happened today 6/28/21
At low speed the power brakes no longer work. The brake pedal has to be pushed to the floor in order to stop. The pedal does not return to its original position and remains soft/spongy and pushed in. Almost caused an accident when this was first discovered.
My 2014 chevy silverado when backing down boat ramp break pedal will go all the way to the floor. I almost lost my whole truck an boat. This just started. I have little over 33 thousand miles on truck.
The contact owns a 2014 Chevrolet Silverado 1500. The contact stated while driving at various speeds, the brakes failed to engage properly when the brake pedal was depressed. The contact stated there was no warning light illuminated. The contact related the failure to an unknown recall. The vehicle was taken to a local dealer and repaired under the unknown recall however, the failure occurred 4 months later. The vehicle was then taken back to the dealer where it was diagnosed with the brake assist pump needing to be replaced. The vehicle was not yet repaired. The manufacturer was not informed of the failure. The failure mileage was approximately 165,000.
Vehicle starts to shake when driven above 70mph. If brakes are applied to reduce speeds from 75-70 the shaking significantly increases, but decreases to the normal shaking once the brakes are released.
The contact owns a 2014 Chevrolet Silverado 1500. The contact stated while driving 10 mph, the brake pedal was depressed however, the braking distance was extended. The contact stated that there was no warning light illuminated. The vehicle was taken to an independent mechanic to be diagnosed. The mechanic was unable to determine the cause of the failure. The vehicle was not repaired. The manufacturer had not been informed of the failure. The failure mileage was approximately 50,507.
When I try to use my brakes they feel like there's no pressure and I have to pump brakes repeatedly to stop. Also feel a little vibration. This does happen every time. Mostly when I'm trying to slow down to park it or stop at a light.
My vehicle VIN does not seem listed for recall GM no. N192268490 or was serviced. Yet, I continue to experience intermittent loss of braking power, especially at slow speeds such as after shifting from drive to reverse for parking, or backing out of a parking space. Much more pressure is required to stop as if loss of power resulting in manual-only braking. This seems to go away when the vehicle is shut off and restarted. Prior to recall, the issue previously resulted in $3000 damage to another family vehicle parked on our private property.
While driving, the "service trailer brakes system" kept coming on. There was a visual and audio warning chime that would not stop. Instead of a single notification to the driver, the intermittent connection would result in the error message continuously re-appearing and chiming. This was extremely distracting and could increase risk of crash. I removed the brake gain controller from the dash and found corrosion on an electrical contact strip. After cleaning it with electronics cleaner, the error message went away.
Service trailer brake system indicator.if vehicle exoeriences this condition and stalls while in motion, there could be an increased risk of a vehicle crash.
Brakes become hard at low speed and when vehicle is at a complete stop. Brakes work normally at higher RPM, gets worse driving in reverse or just letting vehicle creep forward.
A D V E R T I S E M E N T S
- Cave Creek, AZ, USA