Consequence of non-compliance: This condition can reduce the restraining capabilities of the safety belt in the event of an accident.

Seat Belts — Front — Anchorage

Summary

The rivets holding the rear outboard belt D-rings were not heat treated properly causing the heads of the rivets to fracture under load and fail to hold the D-rings to the straps. This does not conform to the requirements of FMVSS no. 210, "seat belt assembly anchorages."

Actions

Dealers will install a reinforcement plate on the rear outboard seat belt assembly anchorages involved in this campaign.

Documents (1)

• Recall Document

Click a tab for more information.