1995 Ford F250. Consumer states engine stall while driving. When the engine stalled, the consumer had to put the shifter into park or neutral and the engine would restart. He also, stated the fuel/water separator was replaced. Also, other repairs included, new hoses, fan clutch, idler wheel, brake pads, relay on glow plug, V-belt, several batteries, the lift pump and the solenoid on the starter. Jb also, the O-rings were replaced. Updated 12/31/12 the dealer found problems with the icp injector press, eba exh back press, map, manifold and ABS. Updated 03/14/13.

- Leesburg, FL, USA

Ongoing / intermittent problem with brake pedal going to the floor and causing loss of braking. Vehicle been in / out of dealer shop on nine occasions, and problem still reoccurring. Feel free to provide any further details on this matter.

- Greenboro, PA, USA

Upon steeping on brake pedal, it goes all the way to the floor which indicates brake problems.

- Junction, TX, USA

While driving experiences erratic operation, poor performance of ABS, under normal conditions, when applying brake at approx. 30mph, the brakes tend to grab/jerk, and stick, no prior warning.

- Kings Bch., CA, USA

Anti-lock brakes failed, resulting in an accident.

- Laguna Hil, CA, USA

ABS brake system failure, brake pedal goes to the floor in a panic stop.

- Phoenix, AZ, USA

ABS braking system became inoperative with no warning.

- Murrysville, PA, USA

ABS, front brake rotors were cracked, when applied brake causing virbration in front end.

- Harrisburg , AR, USA

ABS system failure, loss of braking ability while driving at rolling speed.

- Barrington , RI, USA

Vehicles ABS braking system is intermittently having wheel lock-up.

- Madison Hieg, MI, USA

ABS: Brakes locked up when applied; pedal traveled to floor; caused accident.

- East Aurora , NY, USA