really awful
Crashes / Fires:
0 / 0
Injuries / Deaths:
0 / 0
Average Mileage:
0 miles

About These NHTSA Complaints:

This data is from the NHTSA — the US gov't agency tasked with vehicle safety. Complaints are spread across multiple & redundant categories, & are not organized by problem.

So how do you find out what problems are occurring? For this NHTSA complaint data, the only way is to read through the comments below. Any duplicates or errors? It's not us.

1998 Ford F-250 windows / windshield problems

windows / windshield problem

Find something helpful? Spread the word.
Get notified about new defects, investigations, recalls & lawsuits for the 1998 Ford F-250:

Unsubscribe any time. We don't sell/share your email.

1998 Ford F-250 Owner Comments

problem #3

Jun 092003


  • miles


Rear window cracks and leaks water into the cab. This is evidently a major problem after talking to two auto glass places. Talking to Ford is no help.

- Camanche, IA, USA

problem #2

Dec 201998

F-250 4WD

  • miles
Dealer service depart states: "3 out of 10" trucks have this problem! why no recall?

- Bowie, MD, USA

problem #1

Nov 201998

F-250 4WD

  • miles
Have had 4 failures in the rear suspension system. First time, the traction bars were making a horrible metal-metal creaking/grinding noise; traction bars were replaced. Second time the entire bracket bolted to the frame came loose, sliding and banging around on the frame; tractions bars, traction bar brackets, and traction bar bolts all replaced. Third time air spring (air ride suspension) leaked down and caused the truck to pull to one side (truck was not level; driver's side rear rode very low, passenger side front rode very high); air spring was replaced. Fourth time the traction bar (passenger side) broke; service center not open, plan on taking it in tomorrow. Rear window seal has been 'fixed' twice, yet continues to leak water into the cab, last time shorting out some aftermarket electronics behind the rear seat. Braking at highway speed (50-75) results in a front-end vibration, rotors were turned by the dealer recently due to a front disc brake problem that resulted in the inside pad wearing down to bare metal and much grinding (wear indicators are on the outside pad and were not engaged (squeaking); so they were not indicating pads needed replacement). The other side pads were worn non-parallel to the pad backing (pad was thicker on one edge than the other).

- Colorado Springs, CO, USA

Not what you are looking for?