- April 25: Dodge Dart Clutch Lawsuit Should be Dismissed, Says Chrysler news | 4 days ago
- April 24: Lawsuit: Chrysler Gear Shift Confusing and Dangerous news | 5 days ago
- April 17: Jeep, Dodge and Chrysler Valve Stems Focus of Lawsuit news | 12 days ago
- March 24: Dodge Ram Tie-Rod Lawsuit Will Be Settled news | 36 days ago
- February 19: Chrysler Recalls Dodge Charger and Chrysler 300 recalls | 69 days ago
2005 Dodge Stratus
6 Recalls & Safety Reports
Recall List for the 2005 Dodge Stratus
Official recalls have been issued for the 2005 Dodge Stratus by the NHTSA. The complete details of all recalls are listed below, along with what they cover and the recommended solutions.
Recalls don't cost you anything to get fixed, but most are time-limited, so if your car is affected you should call your local Dodge service department immediately!
If you have questions about a recall, write down your VIN & then call Dodge customer service.
2005 Dodge Stratus AIR BAGS:PASSENGER SIDE FRONTAL NHTSA Campaign #15V338000
Summary: Mitsubishi Motors North America, Inc. (MMNA) is recalling certain model year 2000-2005 Eclipse vehicles manufactured April 5, 1999, to December 17, 2004, 2001-2005 Eclipse Spyder vehicles manufactured January 19, 2000, to March 18, 2005, 2001-2005 Chrysler Sebring vehicles manufactured April 17, 2000, to February 21, 2005, and 2001-2005 Dodge Stratus vehicles manufactured April 17, 2000, to February 22, 2005. In the affected vehicles, the passenger side sun visor may be folded down in such a position that, if the passenger frontal air bag deploys, the passenger side sun visor may detach.
Consequence: If the passenger side sun visor detaches and is propelled rearward, there is an increased risk of occupant injury.
Actions: MMNA will notify their owners, and Chrysler will notify the Chrysler and Dodge owners. Dealers will install a tether strap to retain the passenger sun visor, free of charge. The recall began on July 20, 2015. Owners may contact MMNA customer service at 1-888-648-7820. MMNA's number for this recall is SR-15-005. Chrysler and Dodge owners may contact Chrysler customer service at 1-800-853-1403. Chrysler's number for this recall is R30. For detailed information & supporting documents, see the official NHTSA page concerning recall #15V338000 »
2005 Dodge Stratus SUSPENSION:FRONT:CONTROL ARM:LOWER ARM NHTSA Campaign #10E059000
Summary: Federal-mogul is recalling certain replacement control arm assemblies, part numbers K7425, 10945, fa4510X, K7427, 10946, and fa4611X, sold for use on various passenger vehicles listed above. The ball joint on the control arm assembly can fail causing the ball stud to wear through the control arm housing resulting in noise and/or separation of the ball stud from the housing.
Consequence: If there is a separation of the ball stud from the housing, the driver can loose steering control, possibly resulting in a vehicle crash.
Actions: Federal-mogul will notify owners of record and replace the affected control arms free of charge. The safety recall began on January 28, 2011. Owners may contact federal-mogul at 1-877-489-6659. For detailed information & supporting documents, see the official NHTSA page concerning recall #10E059000 »
2005 Dodge Stratus SUSPENSION:FRONT:CONTROL ARM:LOWER BALL JOINT NHTSA Campaign #09E056000
Summary: Qualis automotive is recalling certain aftermarket ball joints sold for use on certain passenger vehicles. The socket may have been excessively hardened which could cause it to crack near the retaining ring groove allowing the ball stud to separate under impact load. The subject ball joints were sold as four part numbers, D10945, D10946, G10945, and G10946. The affected control arms, D10945 and D10946, are stamped with the following dates on the ball joints: 134308, 135708, 100109, 102709, 104109, 105509, 107609, 108909, 110309, 113209, and 116609. The G10945 and G10946 are the same part as the D10945 and D10946 respectively. They are labeled differently depending on the aftermarket customer.
Consequence: Separation of the ball stud from the socket of the ball joint housing would allow the control arm to collapse and the wheel to fold in causing loss of steering control, possibly resulting in a crash.
Actions: Qualis automotive will replace the ball joints free of charge. The safety recall began on November 9, 2009. Owners may contact qualis automotive at 1-800-493-4128. For detailed information & supporting documents, see the official NHTSA page concerning recall #09E056000 »
2005 Dodge Stratus SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:MASTER CYLINDER NHTSA Campaign #07E023000
Summary: Certain cardone master cylinders with part numbers 10-2925, 10-2987, 10-2987mza, 10-3083, 11-3015, 11-3042, 11-3044, 11-3045, 11-3047, 11-3064, and 11-3156, and with date codes lower than dca7078 sold as replacement equipment for use on the vehicles listed above. The seal on master cylinder can fail and leak brake fluid.
Consequence: Loss of brake fluid can result in poor braking performance, possibly resulting in a vehicle crash.
Actions: Cardone will notify owners and offer to repurchase any defective master cylinders. The recall began during April 2007. Owners can contact cardone at 1-800-777-4780. For detailed information & supporting documents, see the official NHTSA page concerning recall #07E023000 »
2005 Dodge Stratus STEERING:LINKAGES:KNUCKLE:SPINDLE:ARM NHTSA Campaign #04V579000
Summary: On certain sedans and convertible model vehicles, the right steering knuckle may have been damaged during the component manufacturing process.
Consequence: This could cause the steering knuckle to crack and separate from the upper control arm, which could result in a crash.
Actions: Dealers will inspect and replace the right steering knuckle. The recall began on December 27, 2004. Owners should contact DaimlerChrysler at 1-800-853-1403. For detailed information & supporting documents, see the official NHTSA page concerning recall #04V579000 »
2005 Dodge Stratus SEAT BELTS:REAR NHTSA Campaign #04V532000
Summary: On certain sedans, the left and right rear outboard retractor and turning loop bolts on the seat belts may not have been properly tightened.
Consequence: In the event of a crash, the seat occupant may not be properly restrained, increasing the risk of injury.
Actions: Dealers will inspect and tighten the affected fasteners. The recall began on November 15, 2004. Owners should contact DaimlerChrysler at 1-800-853-1403. For detailed information & supporting documents, see the official NHTSA page concerning recall #04V532000 »