10.0

really awful
Crashes / Fires:
0 / 0
Injuries / Deaths:
0 / 0
Average Mileage:
0 miles

About These NHTSA Complaints:

This data is from the NHTSA — the US gov't agency tasked with vehicle safety. Complaints are spread across multiple & redundant categories, & are not organized by problem.

So how do you find out what problems are occurring? For this NHTSA complaint data, the only way is to read through the comments below. Any duplicates or errors? It's not us.

1998 Dodge Ram 2500 drivetrain problems

drivetrain problem

Find something helpful? Spread the word.
Get notified about new defects, investigations, recalls & lawsuits for the 1998 Dodge Ram 2500:

Unsubscribe any time. We don't sell/share your email.

1998 Dodge Ram 2500 Owner Comments

problem #5

Mar 012000

Ram 2500

  • miles

A D V E R T I S E M E N T S

Steering column made a grinding noisy when turning steering wheel or sitting still. Dealer thinks it was caused by defective axle shaft bearings. Chrysler has changed them in new models.they were aware of problem, but no recall has been annouced.

- Kent, WA, USA

problem #4

Aug 012000

Ram 2500 4WD

  • miles
The ring and pinion gear as well as both outer bearings in the rear axle failed at 50000 miles with scheduled maintainance. I had the vehicle repaired at a local driveline shop because the dealer told me that they would not cover the repair. I was told by the repair shop that they were doing as many as four dozen rear end repairs a month on Dodge trucks and full size vans for the same above mentioned dealer. The only reason they are not doing them any longer is because Dodge decided to start replacing the entire rear axle assembly instead. I was also told that this could have lead to a locking of the rear axle assembly while driving which could have proved fatal.

- Sandwich, IL, USA

problem #3

Mar 282000

(reported on)

Ram 2500

  • miles
Premature wear of front bearings. Front wheel bearings have failed five times. Dealer has replaced the spindle, hubs and bearings on both sides.

- Northfield, VT, USA

problem #2

Dec 081999

(reported on)

Ram 2500

  • miles
Rear end requires replacement due to failed bearings which cause noise. Mjs

- Grant, MI, USA

problem #1

Jul 291999

(reported on)

Ram 2500

  • miles
Rear end noise due to failure of the ring and pinion gear and bearing. Mjs

- Berea, KY, USA

Not what you are looking for?