- November 26: Toyota Sienna Recalled To Fix Overhead Assist Grips
- November 23: Toyota Dashboard Melting? Lawsuit Says It Can Happen
- November 12: Toyota Recalls 360,000 Cars, Including 170,000 Toyota Camrys
- November 4: Toyota Recalls Avalon and Camry Cars That Could Lose Steering Control
- October 20: Toyota Recalls 247,000 Vehicles To Replace Dangerous Air Bag Inflators
2009 Toyota Camry
7 Recalls & Safety Reports
Recall List for the 2009 Toyota Camry
Official recalls have been issued for the 2009 Toyota Camry by the NHTSA. The complete details of all recalls are listed below, along with what they cover and the recommended solutions.
Recalls don't cost you anything to get fixed, but most are time-limited, so if your car is affected you should call your local Toyota service department immediately!
If you have questions about a recall, write down your VIN & then call Toyota customer service.
2009 Toyota Camry AIR BAGS:FRONTAL:SENSOR/CONTROL MODULE, SEATS NHTSA Campaign #13V014000
Summary: Southeast Toyota Distributors, LLC (SET) is recalling certain models interspersed through model years 2009 through 2013 as follows: model year 2009-2012 Tacoma, 4Runner, Camry, Camry Hybrid, Prius, and RAV4; model year 2009-2010 Avalon, FJ Cruiser, and Highlander Hybrid; model year 2010-2013 model year Corolla, Sienna and Tundra; model year 2009-2013 Highlander and Venza; model year 2012 Prius V; and model year 2010-2012 Sequoia. During modification by SET to include accessories such as leather seat covers, seat heaters or headrest DVD systems, these vehicles may not have had the passenger seat occupant sensing system calibration tested. Without passing the calibration test, the occupant sensing system may not operate as designed.
Consequence: If the front passenger seat occupant sensing system is out of calibration, the front passenger airbags may not deploy or they may deploy inappropriately for the passenger's size and position. This could increase the risk of personal injury during the event of a vehicle crash necessitating airbag deployment.
Actions: Southeast Toyota will notify owners, and dealers will test the sensitivity of the occupant detection sensors, and recalibrate them as necessary. The recall began on March 21, 2013. Owners may contact Southeast Toyota at 1-800-301-6859. For detailed information & supporting documents, see the official NHTSA page concerning recall #13V014000 »
2009 Toyota Camry VISIBILITY:POWER WINDOW DEVICES AND CONTROLS NHTSA Campaign #12V491000
Summary: Toyota is recalling certain model year 2007-2009 Camry, Camry Hybrid, RAV4, Corolla, Corolla Matrix, Tundra, Sequoia, Highlander, Highlander Hybrid, Yaris, Scion xB, Scion xD and Pontiac Vibe vehicles. The power window master switch assemblies in some of these vehicles were built using a less precise process for lubricating the internal components of the switch assemblies. Irregularities in this lubrication process may cause the power window master switch assemblies to malfunction and overheat.
Consequence: If the switch overheats, it may melt, possibly resulting in a fire.
Actions: Toyota will notify its owners, and dealers will inspect the switch and apply a special grease that inhibits heat build up or replace any switch damaged by the defect, free of charge. Toyota owners that experience a problem with a switch should not attempt to make repairs, but should contact their Toyota dealer or the Toyota Customer Experience Center at 1-800-331-4331. General Motors will contact the Pontiac Vibe owners affected by this recall and GM dealers will inspect and repair switches as necessary. Those owners may contact Pontiac Customer Care at 1-800-762-2737. For detailed information & supporting documents, see the official NHTSA page concerning recall #12V491000 »
2009 Toyota Camry EXTERIOR LIGHTING:BRAKE LIGHTS:SWITCH NHTSA Campaign #12V091000
Summary: Toyota is recalling certain model year 2009 Camry vehicles manufactured from July 1, 2008, through February 28, 2009, and model year 2009-2011 venza vehicles manufactured from October 20, 2008, through January 4, 2011. During assembly of the contact-type stop lamp switch, silicone grease may have come in contact with the surface of the switch which could cause contact resistance. If this occurs, warning lamps could illuminate, a no start condition could result, the shift lever may not shift from the ┐park┐ position, or the vehicle's brake lights could become inoperative.
Consequence: Inoperative brake lights would not warn other drivers that the vehicle is slowing or stopping, increasing the risk of a crash.
Actions: Toyota will notify owners, and dealers will replace the stop lamp switch, free of charge. The safety recall began on April 12, 2012. Owners may contact Toyota at 1-800-331-4331. For detailed information & supporting documents, see the official NHTSA page concerning recall #12V091000 »
2009 Toyota Camry EQUIPMENT:OTHER:LABELS NHTSA Campaign #10V035000
Summary: Gulf states Toyota is recalling certain model year 2005-2010 vehicles for failing to comply with the requirements of Federal Motor Vehicle Safety Standard no. 110, "tire selection and rims." These vehicles were sold between September 1, 2005 and June 2, 2008 without the requisite load carrying capacity modification labels.
Consequence: This does not meet the standard requirements.
Actions: Dealers will mail to consumers the corrected label or the customer will have the option for dealers to install the label free of charge. Dealers will also correct the owner's manual. The safety recall began on May 27, 2010. Owners may contact gulf states Toyota at 713-580-3300. For detailed information & supporting documents, see the official NHTSA page concerning recall #10V035000 »
2009 Toyota Camry EQUIPMENT:OTHER:LABELS NHTSA Campaign #10V036000
Summary: Southeast Toyota is recalling certain model year 2005-2011 passenger vehicles for failing to comply with the requirements of Federal Motor Vehicle Safety Standard no. 110, "tire selection and rims." These vehicles were sold without the requisite load carrying capacity modification labels.
Consequence: A driver may overload a vehicle which may increase the risk of a crash.
Actions: Dealers will mail to consumers the corrected label or the customer will have the option for dealers to install the label free of charge. The safety recall began on May 27, 2010. Owners may contact southeast Toyota at 1-800-301-6859. For detailed information & supporting documents, see the official NHTSA page concerning recall #10V036000 »
2009 Toyota Camry VEHICLE SPEED CONTROL:ACCELERATOR PEDAL NHTSA Campaign #10V017000
Summary: Toyota is recalling certain model year 2005-2010 avalon, model year 2007-2010 Camry, model year 2009-2010 corolla, corolla matrix, rav4, model year 2010 highlander, model year 2008-2010 sequoia, and model year 2007-2010 Tundra vehicles. Due to the manner in which the friction lever interacts with the sliding surface of the accelerator pedal inside the pedal sensor assembly, the sliding surface of the lever may become smooth during vehicle operation. In this condition, if condensation occurs on the surface, as may occur from heater operation (without A/C) when the pedal assembly is cold, the friction when the accelerator pedal is operated may increase, which may result in the accelerator pedal becoming harder to depress, slower to return, or, in the worst case, mechanically stuck in a partially depressed position.
Consequence: The accelerator pedal may become hard to depress, slow to return to idle, or, in the worst case, mechanically stuck in a partially depressed position, increasing the risk of a crash.
Actions: Dealers will install a reinforcement bar in the accelerator pedal which will allow the pedal to operate smoothly. GM will notify owners for the Pontiac vibe please see 10V-018. This service will be performed free of charge. The safety recall is expected to begin on February 5, 2010 and will be completed on March 15, 2010. Owners may contact Toyota at 1-800-331-4331. For detailed information & supporting documents, see the official NHTSA page concerning recall #10V017000 »
2009 Toyota Camry VEHICLE SPEED CONTROL:ACCELERATOR PEDAL NHTSA Campaign #09V388000
Summary: Toyota is recalling certain model year 2004-2010 passenger vehicles. The accelerator pedal can get stuck in the wide open position due to its being trapped by an unsecured or incompatible driver's floor mat.
Consequence: A stuck open accelerator pedal may result in very high vehicle speeds and make it difficult to stop the vehicle, which could cause a crash, serious injury or death.
Actions: Toyota filed an amended defect report on November 25, 2009, stating that dealers will modify the accelerator pedal and, on certain vehicles, alter the shape of the floor surface under the pedal. These changes address the risk of pedal entrapment due to interference with the floor mat. Redesigned accelerator pedals will become available beginning in April 2010 and dealers will replace any modified pedal with the new pedal if desired. Also, dealers will replace any genuine Toyota or Lexus all-weather floor mats with redesigned all-weather mats, or repurchase the previous mats from owners who do not want the new ones. Additionally, software modifications will be installed on Camry, avalon and Lexus ES 350, is 350 and is 250 models that will ensure that the brake overrides the accelerator in the event both brake and accelerator pedals are applied. Toyota will begin mailing letters to owners on December 31, 2009. Owners may contact Toyota at 1-800-331-4331, Lexus at 1-800-255-3987. For detailed information & supporting documents, see the official NHTSA page concerning recall #09V388000 »
Browse Other Camry Years
- 2015 Toyota Camry
- 2014 Toyota Camry
- 2013 Toyota Camry
- 2012 Toyota Camry
- 2011 Toyota Camry
- 2010 Toyota Camry
- 2008 Toyota Camry
- 2007 Toyota Camry
- 2006 Toyota Camry
- 2005 Toyota Camry
- 2004 Toyota Camry
- 2003 Toyota Camry
- 2002 Toyota Camry
- 2001 Toyota Camry
- 2000 Toyota Camry
- 1999 Toyota Camry
- 1998 Toyota Camry
- 1997 Toyota Camry
- 1996 Toyota Camry
- 1995 Toyota Camry