When applying the ABS brakes under normal conditions, the vehicle brakes fail to stop the vehicle.

- Vallejo, CA, USA

ABS problem; intermittently, on regular road conditions, in a regular stopping situation when applying the brakes, the pedal goes to the floorbroad and the Blazer does not stop. This condition has caused (2) crashes since may of 97. One rear end crash and one intersectional crash. Dealer stated that brakes perform properly and cannot find a problem.

- Bryant, TX, USA

Coming off ramp; applying brakes; vehicle did not slow down; took foot off brakes & vehicle accelerated; applied more pressure to brakes to stop. Called for towing & driver restarted vehicle; it revved real fast. Took to dealer & problem not found.

- Summerdale, NJ, USA

Brakes went out on the vehicle. When brakes are applied the vehicle travels about 100 feet befroe stopping. Owner states that brake S go intermittently. The dealer is unable to locate the source of the problem.

- Lakeland, FL, USA

ABS problems; when applying the brakes, mostly on damp conditions in a hard situation, the pedal is very hard and does not move and the vehicle seems to accelerate. The dealer is not able to find a problem with the Blazer.

- Highland, IL, USA

Vehicle is experiencing premature brake failure. ABS does not engage properly. Dealer can't duplicate the problem. Owner took vehicle to a independent mechanic. Mechanic told owner that the ABS computer is improperly engaging.

- Washington, DC, USA

Brakes; the front pads are too small to stop the vehicle if the power assist goes out.

- Tampa, FL, USA

When applying the ABS brakes in a sudden stop situation, there is extended stopping distance.

- Bel Air, MD, USA

The truck is equipped with ABS, the brakes were applied and the pedal went to the floor, and the vehicle did not stop and hit a bus.

- Middletown, NY, USA

Applied pressure to brake pedal and there was a grinding noise/extended stopping distance, resulting in an accident.

- Lisbon, IA, USA

Antilock brake failure.

- Indianapolis, IN, USA

Antilock brakes failed.

- La Crescen, CA, USA

ABS brakes failed to stop vehicle in panic stop situation, pedal went half way down to floor, causing two crashes, nearly a third. According to dealer, brakes working as designed.

- Alhambra, CA, USA

When applying the ABS brakes the pedal travels to the floor, causing extended stopping distance which could cause a vehicle collision. Please add any further details.

- Jersey City, NJ, USA

Vehicle's ABS braking system experiences extended stopping distance, hard pedal then catches into a severe pulsation. Also, failure to stop at times.

- Cedar Bluff, VA, USA

Antilock brakes locked up 10 times, once causing accident.

- Owings Mills, MD, USA

Owner has ABS brakes. He states that brake pedal falls to floor and vehicle does not have any brakes. This problem does not happen often. Vehicle was taken to dealers and they found nothing wrong.

- Longwood, FL, USA

ABS brakes work intermittently, occurs at low speeds. Cause unknown.

- Worthington, IN, USA

Vehicles ABS braking system failed with pedal going to floor and had 2 crashes. This occurred with no prior warning. Between these 2 crashes, vehicle experienced extended stoppings distance.

- New Castle, DE, USA

Brake pedal pulsates when braking. Also, replaced worn out pads and turned rotors. In addition, repaired frozen caliper slides and pins.

- Aimer, IA, USA