- May 11: Ford Super Duty Diesel Fuel Filter Leaks Investigated by Feds investigations | 0 days ago
- May 5: Ford Mustang Shelby GT350 Lawsuit Settlement Reached news | 6 days ago
- May 4: Ford Class Action Lawsuit Filed For California Customers news | 7 days ago
- May 2: Ford Maverick Tail Light Failures Cause Recall of 243,000 Trucks recalls | 9 days ago
- April 29: Fatalities Cause Ford Mustang Mach-E BlueCruise Investigation investigations | 12 days ago
Ford TSB #SSM 51515
2022 Ford Explorer
TSB Document:
Affected Component: ELECTRICAL SYSTEM
- Summary
- 2020-2023 Explorer/Aviator with start/stop push button ignition switch may exhibit an illuminated malfunction indicator lamp (MIL) and powertrain malfunction (wrench) indicator with diagnostic trouble code (DTC) B108A:01 (general electrical failure), B108A:24 (signal stuck high), and/or B108A:9E (stuck on). The ignition mode light emitting diode (LED) indicator may also flash quickly. This condition may be caused by loose wiring terminal crimps on connector C2195 at the push button ignition switch. Examine Pin 1 (CPK34/Gn) first, since it is the only pin with the smallest (26 gauge) wire. To correct this condition, repair terminal crimps per Wiring Diagram (WD) Cell 5. If no wiring terminal faults are found, refer to Workshop Manual (WSM) Section 211-05 for normal diagnostics. The push button ignition switch pinpoint tests in the WSM have been updated.
Click a tab for more information.