- October 13: Chrysler Recalls 470,000 Cars and SUVs to Fix Head Restraint Issues recalls | 35 days ago
- October 2: Dodge Durango and Jeep Grand Cherokee SUVs Recalled for Second Time recalls | 46 days ago
- September 20: FCA Recalls Chrysler Pacifica Minivans To Fix Seat Belt Buckles recalls | 58 days ago
- August 22: Chrysler Recalls Dodge Charger and Dodge Challenger Cars recalls | 87 days ago
2000 Dodge Durango
4 Recalls & Safety Reports
Recall List for the 2000 Dodge Durango
Official recalls have been issued for the 2000 Dodge Durango by the NHTSA. The complete details of all recalls are listed below, along with what they cover and the recommended solutions.
Recalls don't cost you anything to get fixed, but most are time-limited, so if your car is affected you should call your local Dodge service department immediately!
If you have questions about a recall, write down your VIN & then call Dodge customer service.
2000 Dodge Durango SUSPENSION:FRONT:HUB NHTSA Campaign #08E064000
Summary: Skf is recalling 2,805 hub units, part no. BR930361, sold as a service part for 1997-2004 Dodge Dakota vehicles and 1999-2003 Dodge Durango vehicles equipped with 2-wheel drive & rear axle ABS. Due to a specification error, the rotor Pilot for the hub unit may be too long. This results in the wheel to not be seated fully against the hub flange face during mounting.
Consequence: Improper seating of the wheel can result in excessive vibration, brake rotor noise, difficulty removing the wheel after installation and operation of the vehicle, and possibly wheel-end separation during vehicle operation. Should wheel-end separation occur, the driver could loose control of the vehicle, possibly resulting in a crash.
Actions: Skf will notify owners and replace the defective hub units free of charge. The recall began on November 5, 2008. Owners may contact skf vsm North America customer service at 1-800-644-8999. For detailed information & supporting documents, see the official NHTSA page concerning recall #08E064000 »
2000 Dodge Durango ENGINE AND ENGINE COOLING NHTSA Campaign #06E024000
Summary: Certain replacement K&N fuel performance kits, P/nos. 57-1509, 57-1511, 57-1511-1, 57-1517, 57-1517-1, 57-1527, and 57-1530. Also, a small percentage of these kits were sold under the mopar performance parts brand name (P/nos. P5007069 and P5007070). All kits were manufactured from April 20, 1999, through September 23, 2004. These assemblies were manufactured as replacement equipment for certain Dodge pickup trucks and SUVS. A small piece of material from the tube wall could be sucked into the engine throttle body, which could cause the throttle to become jammed in the open position.
Consequence: A jammed open throttle could cause unintended acceleration of the vehicle, possibly resulting in a crash or increased stoping distances when braking.
Actions: K&N will provide owners with a free repair kit along with repair instructions. The recall began on April 20, 2006. For detailed information & supporting documents, see the official NHTSA page concerning recall #06E024000 »
2000 Dodge Durango SUSPENSION:FRONT:CONTROL ARM:UPPER BALL JOINT NHTSA Campaign #04V596000
Summary: On certain sport utility vehicles and pickup trucks equipped with four-wheel drive (4X4), if moisture leaks into the front suspension upper ball joint, evacuation of the lubricant and corrosion of the joint may cause the joint to wear over an extended period of time. This could cause a clunking noise in the front suspension, which may not always be heard by the vehicle occupants.
Consequence: Excessive wear in the upper ball joint may allow it to separate, which could result in loss of control of the vehicle.
Actions: Dealers will replace the front suspension upper ball joints. This safety improvement campaign began on December 21, 2004. Owners can contact DaimlerChrysler at 1-800-853-1403. For detailed information & supporting documents, see the official NHTSA page concerning recall #04V596000 »
2000 Dodge Durango AIR BAGS NHTSA Campaign #01V153000
Summary: Vehicle description: Pickup trucks. Sound deadener material inside the steering wheel could become detached from the cover and housing. Note: The Ram pickup trucks were built at the Warren assembly plant ("S" in the 11th VIN position) from May 16, 2000 through October 23, 2000; St. Louis North assembly plant ("J" in the 11th VIN position) from May 19, 2000 through October 23, 2000; Lago Alberto assembly plant ("M" in the 11th VIN position) from May 23, 2000 through October 23, 2000; and Saltillo assembly plant ("G" in the 11th VIN position) from May 23, 2000 through October 23, 2000. Important: Vehicles that have already had the proper clockspring installed, according to warranty records, have been excluded from this recall. In addition, 1997-2000 model year vehicles that have had a suspect replacement clockspring installed, according to warranty records, have been added to this recall.
Consequence: When this occurs, the material could interfere with the clockspring ribbon and cause an open circuit. The driver air bag system will become disabled, and the air bag warning lamp will illuminate on the instrument panel.
Actions: Dealers will replace the clockspring assembly. Owner notification began June 18, 2001. Also some 1997-200 model year vehicles that, according to warranty records, have had a suspect replacement clockspring installed, will also be included in this campaign. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact DaimlerChrysler at 1-800-853-1403. For detailed information & supporting documents, see the official NHTSA page concerning recall #01V153000 »
Browse Other Durango Years
- 2017 Dodge Durango
- 2016 Dodge Durango
- 2015 Dodge Durango
- 2014 Dodge Durango
- 2013 Dodge Durango
- 2012 Dodge Durango
- 2011 Dodge Durango
- 2009 Dodge Durango
- 2008 Dodge Durango
- 2007 Dodge Durango
- 2006 Dodge Durango
- 2005 Dodge Durango
- 2004 Dodge Durango
- 2003 Dodge Durango